Step 9 - Remote Control - Hunter 41462-01 Installation And Operation Manual

®

STEP 9 - REMOTE CONTROL

STEP 9 - REMOTE CONTROL
STEP 9 - REMOTE CONTROL STEP 9 - REMOTE CONTROL STEP 9 - REMOTE CONTROL
REMOTE CRADLE INST REMOTE CRADLE INST
REMOTE CRADLE INSTALLA REMOTE CRADLE INST REMOTE CRADLE INST
ST ST STANDARD LIGHT SWITCH ANDARD LIGHT SWITCH ANDARD LIGHT SWITCH ANDARD LIGHT SWITCH
ST ST ANDARD LIGHT SWITCH
1. Remove the two screws holding
the switch cover plate. Do not re-
move the cover plate.
2. Orient the control cradle as
shown in Figure 9a, and line up
the two inner mounting holes
with those on the switch, insert
screws, don't over tighten.
Figur Figure 9a Figur e 9a e 9a e 9a
Figur Figur e 9a
18
ALLA ALLA TION TION ROCKER LIGHT SWITCH ROCKER LIGHT SWITCH
ALLA ALLATION TION TION ROCKER LIGHT SWITCH ROCKER LIGHT SWITCH ROCKER LIGHT SWITCH
1. Break off the two tabs by push-
ing outward. See Figure 9b.
2. Remove the two screws holding
the switch cover plate. Do not re-
move the cover plate.
3. Orient the remote cradle as
shown in Figure 9b. Line up the
two outer mounting holes with
those on the switch , insert
screws, don't over tighten.
Remove tabs
Figure 9b Figur Figur e 9b e 9b e 9b
Figur Figur e 9b
WALL INST WALL INST ALLA ALLA TION TION
WALL INST WALL INST WALL INSTALLA ALLA ALLATION TION TION
1. Locate a 2x4 wall stud in a conve-
nient location.
2. Orient the remote cradle as shown
in Figure 9c, over the 2x4 stud.
3. Use the 1" wood screws in either
the inner or outer mounting holes.
Note: Note: Note: Note: Wall anchors and 6-32 x 1" Note:
screws may be used in situations
where mounting to a stud is not pos-
sible. Use the inner mounting holes.
Figur Figur Figur Figure 9c Figur e 9c e 9c e 9c e 9c
41462-01 10/14/2005