Removing Glass Assembly; Screen Mesh; Opening And Trim; Replacing Glass Assembly - Heat & Glo SOULSTICE-LP Owner's Manual

F. Removing Glass Assembly
WARNING
Handle glass doors with care.
• Inspect the gasket to ensure it is
undamaged.
• Inspect the glass for cracks, chips or
scratches.
• Do NOT strike, slam or scratch glass.
• Do NOT operate appliance with glass door removed,
cracked, broken or scratched.
• Replace glass door assembly as a complete appliance.
• Remove the ashlip that is located in front of the glass.
• Remove the side panels located in front of the glass.
• Remove the pull mesh fi rescreen by unhooking it from
the appliance.
• Unlatch the two latches at the bottom of the glass door
(see Figure 12.8).
• Carefully pull the bottom of the door away from the appli-
ance. Lower the door so the tabs on the top of the glass
door pull out of the slots at the top of the fi rebox.
Figure 12.8 Glass Assembly
38
GLASS
ASSEMBLY
LATCHES
Heat & Glo • Soulstice • 2081-900 Rev. K • 7/09
G. Screen Mesh
This appliance comes standard with hanging mesh and
decorative fi rebrick panels. Follow the separate mesh in-
struction for proper installation.
H. Opening and Trim
Install optional marble and brass trim surround kits follow-
ing the separate kit instructions. Marble, brass, brick, tile,
or other non-combustible materials can be used to cover
up the gap between the sheet rock and the appliance.
Do not obstruct the glass opening.
I. Replacing Glass Assembly
• Angle the top of the glass door in toward the appliance
and insert the tabs on top of the glass frame into the slots
at the top of the fi rebox.
• Rotate the bottom of the glass door toward the fi rebox
with slight upward pressure.
• Latch the bottom spring latches securely onto the bottom
glass door tabs.
J. Shutter Settings
Burner
NG LP
3/16 in. 7/16 in.