Advertisement
Installation
Instructions
ADDING
ELBOW FOR EXHAUST
THROUGH
BOTTOM
OF CABINET
• Insert the elbow through the rear opening and connect it to
the dryer internal duct.
• Apply duct tape on the joint between the dryer internal
duct and elbow, as shown on page 7.
l
CAUTION:
"
/_"
Internal duct joints must be secured with tape,
otherwise they may separate and cause a
safety hazard.
ADDING
COVER PLATE TO REAR
OF CABINET
PLATE
(KITWE1M454)
Connect
standard
metal elbows
and ducts to complete
the
exhaust
system.
Cover
back opening
with a plate
(Kit
WI:;I M4,54) available
from
your local
service
provider.
Place
dryer
in final location.
,i_WARNING
- NEVER
LEAVE THE
BACK OPENING
WITHOUT
THE PLATE.
CHANGING
DIRECTION
OF
DOOR OPENING
1. Open the door and remove the filler plugs opposite the
hinges. With the door completely
open, remove the
bottom screws from each hinge on the dryer face. Insert
these screw's about half way into the TOP holes, for each
hinge on the opposite side (where yon removed
the filler
plugs). Apply firm pressure to get the screw started.
2. Loosen the top screws from each hinge on the dryer lace
half way. With one hand holding the top of the door and
the other hand holding the bottom, remove the door
t)om the dryer by lifting it UP and OUT.
3. Rotate the door 180° . Insert the door on the opposite
side
of the opening by moving the door IN and DOWN
until the top hinge and the bottom hinge are resting on
the top screws inserted in step t.
4. Remove the remainiug
screx_.s fio,n the side of the
ope_ing from which the door was removed. With these
screws secure each hinge at the bc,ttom. Tighten the two
top screws on each hinge. Reinsert ihe plasiic plugs on
the side from which the door was removed.
t.OOSENTHETOP
REMOVE THE
SCREWS FROM
BOTTOMSCREW
EACHHINGEON
FROMEACHHINGE
THEDRYER FACE
ONTHEDRYER
HALFWAY,
MOVE THEDOOR INAND
DOWN UNTIL THETOP HINGE
AND THEBOTTOM HINGE ARE
RESTING O NTHE TOPSCREWS
INSERTED INSTEP 1.
SECURE EACH HINGE
ATTHE BOTTOM AND
TIGHTEN T HE TWO TOP
SCREWS O FEACH HINGE.
_7!'{
I }
Pt
