Advertisement
Installation
Instructions
EXHAUST
CONNECTION
,_WARNING
- TO REDUCE
THE
RISK
OF FIRE
OR PERSONAL
INJURY:
• This dryer must be exhausted
to the outdoors.
• Use only metal duct.
• Do not terminate
exhaust in a chimney,
any gas vent,
under
an enclosed
floor (crawl space),
or into an attic.
The accumulated
lint could create a fire hazard.
• Provide an access tot inspection
and cleaning
of the
exhaust
system,
especially
at turns. Inspect
and clean at
least once a year.
• Never
terminate
the exhaust into a common
duct with a
kitchen
exhaust.
A combination
of lint and grease
could
create a fire hazard.
• Do not obstruct
incoming
or exhausted
air.
WE RECOMMEND THAT YOU INSTALL YOUR DRYER
BEFOREYOUR WASHER. THIS WILL PERMIT DIRECT
ACCESS FOR EASIER EXHAUST CONNECTION
THIS DRYERCOMES READY FOR REAR EXHAUSTING. IF
SPACEIS LIMITED, USE THE INSTRUCTIONS IN SECTION
12 TO EXHAUST DIRECTLYFROM THE LEFT SIDE OR
BOTTOM OF THE CABINET.
STANDARD
REAR EXHAUST
WESTRONGLY RECOMMEND
THE USEOF
RIGID METAL E XHAUST DUCT. iFUSING
FLEXABLE METAL D UCT, CUT tTTOTHE PROPER
LENGTH A NDAVOID BUNCHING O FTHE DUCT
BEHIND T HE DRYER.
FOR STRAIGHT
LINE INSTALLATION,
CONNECT THE
DRYER E XHAUST
TOTHE WALL USING
DUCT TAPE.
ELBOW HIGHLY
RECOMMENDED.
ELBOW HIGHLY
RECOMMENDED.
RECOMMENDED
CONFIGURATION
TOMINIMIZE
EXHAUST
BLOCKAGE.
NOTE: ELBOWS WILL PREVENT
DUCT
KINKING
AND COLLAPSING.
LEVELING DRYER
LEVEL
FRONT-TO-BACK.
LEVEL
SIDE-TO-SIDE,
4 LEVELING LEGS
STAND THE DRYER U PRIGHT NEAR THE
FINAL LOCATION ANDADJUST T HE 4 LEVELING
LEGS TOMATCH THEHEIGHT O FYOUR WASHER.
ADJUST T HE2ANT!-TIP L EGS TOCONTACT
THE FLOOR.
2ANTI-TIP LEGS
5
i
Advertisement
