Powering-Up Amulet - Entone Amulet 300 User Manual

Amulet High Definition IP Television Receiver User's Guide
Chapter
7
7

Powering-Up Amulet

Follow these steps to power up the Amulet:
1. Follow your TV/Network service provider's instruction to connect the Amulet to your network modem or
network access unit using the Ethernet cable or Wireless Antennae (optional)
Figure 7-1 Connecting Amulet (Ethernet connection)
Figure 7-2 Connecting Amulet (Wireless connection)
2. Plug the socket end of the AC/DC adapter into the wall socket and the DC jack into the power
connector on the Amulet.
3. The Amulet front panel power indicator will illuminate in blue color.
4. The ―LINK‖ LED indicator will illuminate in green color
NOTE: The ―HD‖ LED indicator will illuminate only if the output resolution is 720p or higher. The
―RECORD‖ LED indicator will illuminate only if the (DVR) is enabled and recording assets to the hard disk
drive is in progress. (Please refer to your middleware or service provider about the DVR functionality)
19
Copyright  2010 Entone, Inc. All rights reserved