Remove two nuts from
one end ot the top panel
frame. Remove end
piece. Slide decorative panel into
Replace end piece
top grille is aligned with
top trim on cabinet. Use
six screws to tighten top grille frame
to retrigarator. Check that the power
is in the "ON" position.
Attach top grille decorative panel
assembly to the keyhole bracket on
the frame and pull down to secure.
If the top grille decorative panel
does not fit evenly within frame, the
keyhole bracket can be moved side
to side by adjusting the bracket
screws or the decorative panel
bracket can be moved up or down
by adjusting the decorator panel
Personal injury Hazard
Reinstall set screws otter
door swing is set.
Failure to do so could result
in personal injury.
Check that doors can
open freely. it not, the
door stops or hinges
can be adjusted.
To adjust horizontally:
screw in top and bottom hinges with
Determine the door
Hold door in that
position and tighten the set screws.
The doors have stops at 90°, 115O
and 137" positions.
it the door
stops cannot be adjusted to clear
need to be mitered. (Consult your
builder to adjust countertops.)
To adjust vertically:
not remove, top and bottom hinge
screws. Lift door and bottom hinge
to desired position. Tighten bottom
hinge screws and then top hinge
Check the water
bottom ot the refrigerator
again for leaking.
Any leaking can
and floor damage.
Open both doors. Use
two screws to attach
bottom grille to cabinet.
Put shelves and bins
into the refrigerator
Remove protective film from door
controls to the midpoint
between "COLD" and "COLD&T".
Check that the compressor
erating properly. Check that ail five
interior lights are working.
To get the most efficient
use from your new
and Care Guide. Keep
Ins talla tion Ins true tions
and Guide close to