Table of Contents
Advertisement
Chapter 4
Configuring the 6T3 Line Card
Using the show interfaces Command
The show interfaces command displays status information (including the physical slot and interface
address) for the interfaces you specify. The example that follows specifies serial interfaces.
Note
The outputs that appear in this document may not match the output you receive when running these
commands. The outputs in this document are examples only.
Cisco 7304 Routers
Following is an example of the show interfaces command for Cisco 7304 routers. In this example, the
serial interfaces (0 to 5) are on a 6T3 line card in slot 5; also, the status information for interfaces 1
through 5 is omitted. (Interfaces are administratively shut down until you enable them.)
Router# show interfaces serial 5/0
Serial5/0 is up, line protocol is up
Hardware is Packet over DS3
Internet address is 50.1.1.2/8
MTU 9216 bytes, BW 44210 Kbit, DLY 200 usec,
Encapsulation HDLC, crc 16, loopback not set
Keepalive not set
Scramble enabled
Last input 15:00:13, output 15:00:13, output hang never
Last clearing of "show interface" counters never
Input queue: 0/75/0/0 (size/max/drops/flushes); Total output drops: 0
Queueing strategy: fifo
Output queue :0/40 (size/max)
30 second input rate 0 bits/sec, 0 packets/sec
30 second output rate 0 bits/sec, 0 packets/sec
[Additional display text omitted from this example]
OL-3449-02
reliability 255/255, txload 1/255, rxload 1/255
5 packets input, 520 bytes, 0 no buffer
Received 0 broadcasts, 101 runts, 0 giants, 0 throttles
0 parity
0 input errors, 0 CRC, 0 frame, 0 overrun,, 42 abort
5 packets output, 520 bytes, 0 underruns
0 output errors, 0 applique, 4 interface resets
0 output buffer failures, 0 output buffers swapped out
4 carrier transitions
Clear Channel 6-Port T3 (DS3) Line Card Installation and Configuration
Checking the Configuration
4-13
Advertisement
Table of Contents
