Cisco Catalyst 3560-C Installation Manual page 17

Chapter 2 Switch Installation
Read the wall-mounting instructions carefully before beginning installation. Failure to use the
Warning
correct hardware or to follow the correct procedures could result in a hazardous situation to people
and damage to the system. Statement 378
Caution Do not wall-mount the switch with its front panel facing up. Following safety regulations, wall-mount
the switch with its front panel facing down or to the side, to allow sufficient airflow and to provide easier
access to the cables.
Figure 2-13
1
Switch with the mounting tray attached
2 Magnet
Warning To prevent airflow restriction, allow clearance around the ventilation openings to be at least:
3 in. (7.6 cm) Statement 1076
After you mount the switch, see the
about configuring the switch.
OL-23803-02
Wall-Mounting with a Magnet
1
"After Installing the Switch" section on page 2-31
2
3
Metal wall
Catalyst 3560-C and 2960-C Switch Hardware Installation Guide
Mounting the Switch
3
for information
2-17