Before Setting Oven Controls; Removing, Replacing & Arranging The Oven Racks - Kenmore 790.9210 Use & Care Manual

Before Setting Oven Controls

Oven vent location
The oven vent is located under the left side of the contr
panel panel
panel (See Fig. 1). When the oven is on, warm air passes panel panel
through this vent. This venting is necessary for proper air
circulation in the oven and good baking results. Do not
block oven vent.
oven vent
Removing, replacing and arranging racks
Always use pot holders or oven mitts when
using the oven. When cooking, the oven interior and
exterior, oven racks and cooktop will become very hot
which can cause burns.
Protective Liners — DO NOT USE
ALUMINUM FOIL to line the oven bottom. Only use
aluminum foil as recommended in this manual. Improper
installation of these liners may result in risk of electric
shock, or fire.
Arranging - always arrange
the oven racks when the oven
is cool (prior to operating the
oven).
To remove - pull the rack
forward until it stops. Lift up
front of rack and slide out.
To replace - fit oven rack
onto the rack guides on both
sides of oven walls. Tilt the
front of oven rack upward
and slide the rack back into
place. Be sure oven racks are
level before using.
Recommended oven rack positions by food type:
Food type
Broiling
Cookies, cakes, pies, biscuits & muffins
Frozen pies, angel food cake, yeast, bread
and casseroles
Small cuts of meat or poultry
Turkey, roast or ham
under the left side of the control ol ol ol ol under the left side of the contr under the left side of the contr
under the left side of the contr
Fig. 1
7
6
5
4
3
2
1
Fig. 2
Position
See broil
4 or 5
2 or 3
1 or 2
1 or 2
Types of oven racks
flat
oven rack
The flat oven rack (some models) or flat handle oven rack
(some models) may be used for most cooking needs.
The offset oven rack (some models) is designed to place
the base of the rack about 1/2 of a rack position lower
than flat oven racks. This design provides several additional
possible positions between the flat rack positions.
To maximize oven cooking space place the bottom oven
rack (on some models) in the lowest rack position for
roasting large cuts of meat.
some
Air circulation in the oven
models
For best baking results allow 2-4" (5-10 cm) around the
cookware for proper air circulation and be sure pans and
cookware do not touch each other, the oven door, sides or
back of the oven cavity. Hot air must be able to circulate
around the cookware in the oven for even heat to reach
around the food (See Fig. 3 ).
Baking layer cakes with 1 or 2 oven racks
For best results when baking cakes or cookies using 2 oven
racks, place cookware on rack positions 2 and 5 (6 using
the offset oven rack on some models). For best results when
baking cakes or cookies using a single oven rack, place
cookware on rack in positions 2, 3 or 4 (See Fig. 2).
7
bottom
oven rack
Fig. 3
flat handle
oven rack
offset
oven rack