Craftsman 917.28008 Operator's Manual page 25

OPERACIÓN
Estos símbolos pueden aparecer sobre su tractor o en la literatura proporcionada con el producto.
Aprenda y comprenda sus significados.
MARCHA ATRÁS NEUTRO ALTO
MOTOR MOTOR
SISTEMA ENCENDIDO
APAGADO EN MARCHA
FUNCIONAMIENTO
ATRÁS (ROS)
LUCES
BATERÍA MARCHA
ENSENDIDAS COMBUSTIBLE
ACCESORIO DEL ACCESORIO DEL
PELIGRO, GUARDE LAS
EMBRAGUE EMBRAGUE
MANOS Y LOS PIES LEJOS
ENGANCHADO
DESENGANCHADO
RUEDA LIBRE
(Solamente para los
modelos automatico)
No seguir las siguientes instrucciones
puede provocar heridas o muerte. Los
símbolos de aviso de seguridadse utilizan
para identificar informaciones de seguridad
relativas a peligros que puedenprovocar la
muerte, heridas graves y/o daños a la
máquina.
RÁPIDO
BAJO ESTRANGU- LENTO
LACIÓN
MOTOR FRENO DE
ALTURA DE LA
ESTACIONAMIENTO SEGADORA
MARCHA
PALANCA DE MANDO
ATRÁS HACIA ADELANTE
CRUCERO
15
PELIGROS DE
MANTENGA EL MANTENGA EL
PENDIENTES
AREA DESPEJADA AREA DESPEJADA
(Vea la sección de las reglas de seguridad)
PELIGRO indica un peligro que, si no se evita,
provoca muerte o lesiones graves.
ADVERTENCIA indica un peligro que, si no se evita,
puede provocar muerte o lesiones graves.
PRECAUCIÓN indica un peligro que, si no se evita,
puede provocar lesiones ligeras o moderadas.
PRECAUCIÓN cuando se utiliza sin el símbolo de aviso,
indica una situación que puede provocar daños al
tractor y/o al motor.
SUPERFICIES CALIENTES indica un peligro que,
si no se evita, puede provocar la muerte, lesiones
graves y/o danos a la máquina.
FUEGO indica un peligro que, si no se evita, puede
provocar la muerte, lesiones graves y/o danos
a la máquina.
48
CLEANING
• Clean engine, battery, seat, finish, etc.
of all foreign matter.
• Clean debris from steering plate.
Debris can restrict clutch/brake pedal
shaft movement, causing belt slip and
loss of drive.
CAUTION: Avoid all pinch points and
movable parts
LEVANTAMIENTO
DE LA SEGADORA
PEDAL DE FRENO /
DE EMBRAGUE
Steering
Plate
15
Steering System, Dash,
Fender and Mower Not Shown
• Keep finished surfaces and wheels
free of all gasoline, oil, etc.
• Protect painted surfaces with automo-
tive type wax.
We do not recommend using a garden hose
or pressure washer to clean your tractor
unless the engine and transmission are
covered to keep water out. Water in engine
or transmission will shorten the useful life of
your tractor. Use compressed air or a leaf
blower to remove grass, leaves and trash
from tractor and mower.
DECK WASHOUT PORT
Your tractor's deck is equipped with a
washout port on its surface as part of its
deck wash system. It should be utilized af-
ter each use.
1. Drive the tractor to a level, clear spot
on your lawn, near enough to a water
spigot for your garden hose to reach.
IMPORTANT: Make certain the tractor's
discharge chute is directed AWAY from your
house, garage, parked cars, etc. Remove
bagger chute or mulch cover if attached.
2. Make sure the attachment clutch control
is in the "DIS EN GAGED" position, set
the parking brake, and stop the engine.
3. Thread the nozzle adapter (packaged
with your tractor's Operator's Manual)
onto the end of your garden hose.
4.
IMPORTANT: Tug hose ensuring connec-
tion is secure.
5.
Clutch/brake pedal
Clean
top side
CAUTION:
Pinch
6.
Points
IMPORTANT: Recheck the area making
certain the area is clear.
7.
8.
9.
10. Move the tractor to a dry area, prefer-
fitting could expose you or others to thrown
objects from contact with the blade.
• Replace broken or missing washout fitting
immediately, prior to using mower again.
• Plug any holes in mower with bolts and
locknuts.
25
Pull back the lock collar of the nozzle
adapter and push the adapter onto the
deck washout port at the left end of the
mower deck. Release the lock collar to
lock the adapter on the nozzle.
Turn the water on.
Hose
Nozzle
Adapter
Washout Port
While sitting in the operator's position
on the tractor, re-start the engine and
place the throttle lever in the Fast "
position.
Move the tractor's attachment clutch
control to the "ENGAGED" position.
Remain in the operator's position
with the cutting deck engaged until the
deck is cleaned.
Move the tractor's attachment clutch
control to the "DIS EN GAGED" posi-
tion. Turn the ignition key to the STOP
position to turn the tractor's engine off.
Turn the water off.
Pull back the lock collar of the nozzle
adapter to disconnect the adapter from
the nozzle washout port.
ably a concrete or paved area. Place
the attachment clutch control in the
"ENGAGED" position to remove excess
water and to help dry before putting the
tractor away.
WARNING:
A broken or missing washout
"