Table of Contents
Advertisement
Explanations of the User's "daily use" Programmable Features:
• Feature
#
1, "Coded Override", may be used another programmable feature, "Ignition
Activated Anti-Carjacking". See "Feature
• Feature
#
2 is "Engine Running Time". When MARS remotely starts the engine, the run
time before automatic shut-off is adjustable. A 10 minute run time is the factory setting,
with options of 20, 30 or 40 minutes. When programming (see page 12) press "UNLOCK"
for 20 minutes; press "START" for 30 minutes; press "TRUNK" for 40 minutes; or press
"LOCK" for 10 minute setting.
• Feature
#
3, "Doors Lock/Unlock Upon Ignition On/Off", has the MARS automatically lock
the doors when the ignition key is turned on, and unlock them when the key is turned off.
• Feature
#
4, "Horn Confirmation With Doorlocking", offers several forms of audible confir-
mation when the doors are remotely locked and unlocked. Audible confirmations in any
form require the connection of the MARS to the vehicle's horn, or to an optional electronic
siren. Confirmation with remote doorlocking has the horn chirp once after locking, and
twice after unlocking. Two volume levels are selectable and an "On Demand" operation
whereby the first press of the "LOCK" or "UNLOCK" button is silent, and a second press
will produce the confirmation chirp or chirps.
When programming (see page 12) press "UNLOCK" for the On Demand operation;
press "START" to turn off the confirmation chirps; press "TRUNK" for the Quiet chirp; or
press "LOCK" for louder chirp (the factory "Medium" setting).
• Feature
#
5, "Horn Confirmation With Starting", is similar to the previous feature, and
#
7".
22 Gauge Blue Wire:
500mA ( - ) Ignition Output
Connection If Needed.
This 22 gauge Blue wire is a
500mA Negative output,
which has the same
operation as the
12 gauge Blue
Red Wire
Ignition output.
NOTE: If an
additional Acc-
Red
essory output is
3-pin
needed, use the
Harness
programmable
built-in relay (Yellow/Green wire),
as described on page 25.
Wiring Connections - 12 Wire Harness
18-Gauge Black Wire:
Connection Required.
Connect the Black wire to a very good, clean chassis ground.
A recommended connection is to an existing machine-thread bolt, either in the driver's kick
panel, steering column area or a major structural member behind the dash. Small dash
To Additional
Optional
Starter Circuit
Relay
30
86
85
87a
87
Fused
constant
12 Volts
To Additional
Ignition Circuit
30
86
85
87a
Optional
87
Fused
Relay
constant
12 Volts
System Ground
Hide quick links:
Advertisement
Table of Contents
