Omega MAX-E Operation Manual page 24

Hide thumbs Also See for MAX-E:
Table of Contents

Advertisement

10) 3 Red Flashes / Pause = System was triggered by an open door.
11) 4 Red Flashes / Pause = System was triggered by the sensor.
• Turning on the ignition will clear the Zone Violation.
Starting System Status:
The primary function of the Status Indicator Light
is to indicate the status of the security system:
12) Off = The remote starter system is off and in standby mode. The security
system is disarmed and not performing automatic functions.
13) Flashing Slow Green = The engine is running via the remote starting system.
14) Flashing Fast Green = A remote start command has been received, and the
system is in the process of starting the engine.
Remote Starting Diagnostics:
Mode, the Status Indicator Light illuminates solid Red. However, when this occurs,
the Status Indicator Light will flash Red, then 1 to 6 Green flashes before resuming
solid Red. This indicates why the engine stopped running from the last previous
remote starting.
15) Red / 1 Green Flash / Red = Programmed run time expired.
16) Red / 2 Green Flashes / Red = Brake was pressed or hood opened.
17) Red / 3 Green Flashes / Red = Engine stalled or bad tach signal.
18) Red / 4 Green Flashes / Red = Received transmitter command to stop.
19) Red / 5 Green Flashes / Red = Gear selector removed from "park".
20) Red / 6 Green Flashes / Red = Security system triggered or low voltage.
Combination Indications:
remote starting operations are, or have been, simultaneous.
21) Slowly Alternates Red & Green = Full Valet Mode (page 21).
22) Solid Green w/ Red Flash = Security Armed with Starting Valet Mode.
23) Solid Red w/ Green Flash = Remote starter system engaged with security
24) Rapidly Alternates Red & Green = Remote starter system engaged with
25) Slow Flashing Green w/ 1 to 4 Red Flashes = This indication is during remote
start operation after disarming the alarm, and shows that the pre-
viously Armed alarm was activated and reset prior to the remote
starting. The Red flashes are the Zone Violation (previous page),
occurring with the "engine running"
26) Slowly Flashing Red 3 Times, Green 1 Time = The system is programmed
for manual transmission remote starting, and is armed and ready
for starting.
Whenever the system is placed into Valet
These indications occur when security and
system in Valet Mode.
security system armed.
indicator.
Page 22
ANTI-CARJACKING PROTECTION
The Omega MAX-E is equipped with three separately programmable Anti-
Carjacking Protection features. The Anti-Carjacking Protection operation may be
selectively activated by the ignition, by an open door, or by the transmitter.
How It Works:
Once the Anti-Carjacking Protection process has begun, the user has 53 seconds
to cancel the process by pressing the Valet Switch once. If Anti-Carjacking
Protection is not cancelled, 53 seconds after being activated the siren will begin to
chirp for 7 seconds to alert the user that the system is about to enter into an alarm
condition.
If the Anti-Carjacking Protection process is not cancelled before the 60 second
countdown expires, the system will enter an alarm condition, sounding the siren
and flashing the parking lights. 30 seconds after this occurs, or should the igni-
tion be turned off in the meantime, the stater interrupt will engage.
Once the system enters the alarm condition, it will not respond to the
transmitter, nor will the system reset automatically after 60 seconds.
Once in the alarm condition, the Anti-Carjacking Protection can only be disen-
gaged by:
Step 1 Turning the vehicle's ignition off.
Step 2 Turning the ignition back on.
Step 3 Within 5 seconds, perform an Emergency Override using the
Valet Switch.
Level #1: Anti-Carjacking Protection activated by the ignition:
The Anti-Carjacking Protection process is started every time the vehicle's ignition
is turned on. This is programmable feature #25.
Level #2: Anti-Carjacking Protection activated by an open door:
The Anti-Carjacking Protection process is started by a door of the vehicle being
opened, but only if the ignition is on when the door is opened. This is programmable
feature #26.
Level #3: Anti-Carjacking Protection activated using a transmitter:
The Anti-Carjacking Protection process is started by pressing holding the
transmitter's "lll" button for 3 seconds, but only if the vehicle's ignition is on.
This is programmable feature #27.
Page 23

Advertisement

Table of Contents
loading

Table of Contents