Omega Freedom 500 Owner's Manual page 14

Hide thumbs Also See for Freedom 500:
Table of Contents

Advertisement

To Activate Remote Panic:
Press & Hold for 3 Seconds the "Arm/Lock"
Button OR the "Disarm/Unlock" Button
OR
Hold 3
Hold 3
seconds
seconds
Upon Activating Panic:
• The vehicle's doors will lock or unlock.
• The siren will sound.
• The vehicle's exterior parking lights will flash.
Remote Panic can be activated anytime, whether the vehicle's ignition is turned
on or off, and has a 60 second duration (regardless of the 30 or 60 second activa-
tion setting) unless a transmitter is used to stop it. At the end of the 60 second
cycle, the system will reset and be in either the armed state (if activated by the
"Arm/Lock" button) or in the disarmed state (if activated by "Disarm/Unlock").
THE SIREN SOUNDS
THE PARKING LIGHTS WILL
FLASH
THE DOORS WILL LOCK LOCK
OR UNLOCK*
(*if an optional interface is connected)
Page 14
Zone Testing & Zone Violation: Are related visual indicators, via the LED Status
Indicator; the first shows currently violated zones while the system is disarmed,
and the second, should the system be activated, shows which zone caused the
activation after the fact. These are the codes for both operations:
1 Flash /Pause = is the current sensing zone circuit.
2 Flashes /Pause = is the hood or trunk zone circuit.
3 Flashes /Pause = is the door zone circuit.
4 Flashes /Pause = is the sensor zone circuit, including Prewarning Detection.
Zone Testing operates while the system is disarmed, and shows if a protected
zone is in a violated state. In using Zone Testing, for example, while the system
is disarmed, whenever a door is open the LED Status Indicator will flash 3 times
between pauses. Should multiple protected zones be violated at the same time,
all will be shown in sequence.
Zone Violation operates if the system has been armed, and then activated. During
the activation, the LED Status Indicator will flash the Violation, and then revert to
the normal slow flash when the system rests itself, then, upon disarming, the LED
will change to flash the Violation Code, and will continue to do so until the ignition
switch is turned "On". Should multiple activations occur during a single armed
period, up to four Zone Violations will be shown upon disarming.
Page 19

Advertisement

Table of Contents
loading

Table of Contents