Install Safe-T-Beam System - Genie Excelerator Manual

Complete with intellicode remote control and series ii electronics
Hide thumbs Also See for Excelerator:
Table of Contents

Advertisement

Installation Step 6:
ELECTRICAL WARNING
Ensure there is No power to the Opener before installing
Safe-T-Beam® System Wires. If Opener is plugged into outlet,
Unplug it now.
The Opener will not close the door automatically unless the
Safe-T-Beam® System is installed.
A
Install Safe-T-Beam® Source and Sensor (Figure 25):
Mark both sides of garage door frame or wall 6"
above floor.
Hold Bracket against door frame or wall. Check if Bracket
extends out from wall far enough so tongue of Bracket is
beyond door, tracks, or any door hardware. If not, Safe-T-
Beam® Mounting Bracket Extensions are available from a
Genie Factory Authorized Dealer or through the
Accessories Order Form.
Blocks of wood, etc. may be substituted
for extensions.
Position top of Mounting Bracket at 6" mark and fasten
with 2 (#10-16 x 1-1/4") Phillips Hex Head Screws
per Bracket.
Mounting Brackets can be attached to brick walls or concrete
floor using masonry anchors (not included).
B
Attach Safe-T-Beam® Source (Red LED) and Sensor (Green
LED) to Brackets (Figure 25):
For single-door garages.
Determine which side of garage receives the most
direct sunlight, and place Source (Red LED) on this
side whenever possible.
For multiple-door garages see (Figure 26).
Preventing crossed signals is critical.
Place Source and Sensor modules on adjacent doors
facing in opposite directions.
To help prevent interference from the sun, the Safe-T-Beam®
Sensor (Green LED) may be placed further away from the
door opening, where it will spend more time in the shadows.
Slide the Safe-T-Beam® Source and Sensor onto the
tongues of the Brackets until they click into place.
Check final height of Lens (Figure 27).
16
C
I
S
-T-B
H
NSTALL
AFE
S
YSTEM
NOTE
NOTE
NOTE
Safe-T-Beam® Sensor
®
EAM
(Green LED)
Safe-T-Beam® Source
(Red LED)
RED
LED
ONE DOOR
GARAGE
GREEN
LED
THREE DOOR
GARAGE
Figure 26 Source/sensor Locations
Figure 27 Final Check Safe-T-Beams®
For Help, call 1-800-35-GENIE or visit www.geniecompany.com
Slide onto
tongue of
Bracket until
it clicks into
place
Figure 25 Install Safe-T-Beams®
SUN
GREEN
GREEN
RED
LED
LED
LED
TWO DOOR
GARAGE
RED
RED
GREEN
GREEN
LED
LED
LED
Top edge of Lens
5" - 6" above floor
Top of
Bracket 6"
6"
above
floor
RED
GREEN
LED
LED
RED
LED
LED

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

PowerliftPowerlift excelerator

Table of Contents