3.
Connect the other end of the power cable to a suitable
nearby AC power socket outlet.
It is not necessary at this stage to connect the printer to a
host computer.
4.
Switch on the printer. The display panel will read
INITIALIZING for a few seconds, then will read ON LINE.
The READY light will be on, all others will be off. The
printer is now ready.
If the display tells you that one or more toner colours are
low, switch the printer off for a few seconds, then on again.
The mechanical cycling you hear will dispense some toner
into the image drum cartridges, and the display should
then read ON LINE. It may be necessary to repeat this two
or three times when the machine is new.
If the display says that one or more image drums are not
installed, switch off the printer, open the top cover and
check that all four image drum cartridges are properly seated
in their correct positions.
14
Built-in Print Samples
Your printer has a set of printable pages built in. These provide
useful information about the printer, and also serve to test the
printing function.
Demo Page
The demonstration page shows some of the features of your
new printer.
1.
Press the ON LINE key on the operator panel to take the
printer OFF LINE.
2.
Press and hold the Print Demo key for more than 2 seconds.
The display will read PRINT DEMO PAGE, and after a few
seconds (a little more if the printer has been in POWER
SAVING mode) a demo page will emerge face down into
the stacker tray on top of the printer.
Fonts Page
Your printer can produce a colour sample of all its built in
fonts.
1.
Press the ON LINE key if necessary to ensure that the
display reads OFF LINE.
OKIPAGE 8c