Menu; General; Changing Menu Settings - Furuno CSH-5 MARK-2 Operator's Manual

General

Changing Menu Settings

The CSH-5 MARK-2 employs three menu screens, menu-1 menu-2,
and system menu, to preset infrequently used functions.
Procedure to Change Menu Settings
1. Turn off the transmitter with the TX key; LED flickers.
2. Press the MENU key. The menu-1 appears.
3. To select another menu, operate the GAIN control.
4. Select a menu item with the RANGE switch and change the set-
ting with the GAIN control.
Note: Setting for the items shown in red are locked. To unlock the
settings, change the "menu select" setting on the system menu.

Menu-1

The figure below shows menu-1.
The contents of the menu-1 are same as the scan menu described on
page 8.
** SCAN MENU **
[MENU MODE] :
HUE :
TX OUTPUT : 8
PULSELENGTH : 7
TX CYCLE : 10
TVG NEAR : 6
TVG FAR : 7
AUTO SCN WDTH :
AUTO TLT WDTH :
HOR BEAM ANGL : WIDE
VER BEAM ANGL :
RES COL CURVE : LINEAR
COL EMPHASIS : 1 (LOW)
FUNC KEY PROG :
( RANGE SW : U/D GAIN SW : L/R)
MENU-1 MENU-2
1 2
10 20
2~10 4~14
NARROW
WIDE NARROW
1
2
FUNC1 FUNC2
32
10. MENU
SYSTEM
3 4
40 60
6~20 10~26
2 3
3 4 (HIGH)
FACTORY