GE 200D8074P051 Owner's Manual page 25

Installation Instructions
E] PUT THE REFRIGERATOR IN PLACE
Move the refrigerator to its final location.
FI LEVEL THE REFRIGERATOR
The refrigerator can be leveled by adjusting the
rollers located near the bottom hinges.
.......... ZZ:J
Rollers Raise
Rollers hove three purposes:
, Rollers adjust so the door closes easily when
opened about halfway. (Raise the front about
5/8" [16 mm] from the floor.)
. Rollers adjust so the refrigerator is firmly
positioned on the floor and does not wobble.
. Rollers allow you to move the refrigerator
away from the wall for cleaning.
To adjust the rollers on 23' (33" wide), 25', 26',
27' and 29' models:
Turn the roller
adjusting screws
clockwise to roise
the refrigerator, --------
counterclockwise
to lower it. Use a
3/8" hex socket or
wrench, or an
adjustable wrench.
Roller odjusting screw
[] LEVEL THE REFRIGERATOR (cont.}
To adjust the rollers
on 23'/25'
CustomStyle" models:
Turn the front roller
adjusting screws
clockwise to roise the
refrigerator,
counterclockwise to
Roller adjusting screws
lower it. Use a 3/8" hex
wrench with extension, or an adjustable wrench.
These models also have rear adjustable rollers
so you con align the refrigerator with your
kitchen cabinets. Use a 3/8" hex wrench with
extension to turn the screws for the rear rollers-
clockwise to raise the refrigerator,
counterclockwise to lower it.
LEVEL THE DOORS
Adjust the refrigerator door to make the doors
even at the top.
To align:
Using a 7/16" wrench, turn the door adjusting
screw to the right to raise the door, to the left
to lower it.
NOTE:
A nylon plug, imbedded in the threads of the
pin, prevents the pin from turning unless a
wrench is used.
After one or two turns of the wrench, open and
close the refrigerator door and check the
alignment at the top of the doors.
Doors should be even ot top
25