Frigidaire 242292000 Use & Care Manual page 22

Locating the Fi[te_
Your refrigerator is equipped with water filtering system.
The water fitter system fitters all dispensed drinking
water, as we[[ as the water used to produce ice.
Water Filter
The water filter is located at the top right side of the
fresh food compartment.
Replacing the Water Filter
In genera[, you should change the water fitter every six
months to ensure the highest possible water quality. The
Water Fitter Status tight on the user interface prompts
you to replace the fitter after a standard amount of water
(200 gallons/757 liters for Pure$ource Ultra
TM)
has
flowed through the system. The water filter status light
on this model is not performance tested or certified
by NSF.
If your refrigerator has not been used for a period of time
(during moving for example), change the filter before
reinstalling the refrigerator.
Filter Cartridge
Ordering Replacement Filters
To order your replacement filters, please visit our online
store at www.frigidaire.com/store, by calling tolFfree
at 877o808-4195, or by visiting the dealer where you
purchased your refrigerator. Frigidaire recommends
that you order extra filters when you first install your
refrigerator, and that you replace your filters at [east once
every six months.
Here is the product number to request when ordering:
PureSeurce Ultra
TM
Water Filter
Part #ULTPJ_WF
More about your Advanced Water Filter
The Pure$ource Ultra
TM
ice and water filter
system is tested and certified to NSF/ANSI
Standards 42 and 53 for the reduction of claims
specified on the performance data sheet.
Do not use with water that is microbiologically unsafe or
of unknown quality without adequate disinfection before
or after the system. Systems certified for cyst reduction
may be used on disinfected waters that may contain
filterable cysts.
Test & certification results,
- Rated Capacity o 200 gallons/757 liters for
Pure$ource Ultra
TM
ice and water filter
o Rated service flow o .50 gallons per minute
Operating Temp.: Hin. 33°F, Hax. 100°F
Haximum Rated Pressure o 100 pounds per
square inch
Recommended Hinimum Operating Pressure: 30
pounds per square inch
To replace your Pu_u_ U_
TM
water fiJter:
It is not necessary to turn the water supply off to change
the filter. Be ready to wipe up any small amounts of water
released during the filter replacement.
:L Turn Off the ice maker by raising the wire signal arm.
2 Remove the filter by pushing on the end/face of
the filter.
3
4
5
6
7
8
Slide the old water filter cartridge straight out of the
housing and discard it.
Unpackage the new filter cartridge. Using the
alignment guide, slide it gently into the filter housing
until it stops against the snapoin connector at the
back of the housing.
Push firmly until the cartridge snaps into
place (yeu sheu[d hear a click as the cartridge
engages the snap-in connector)o
Turn On the ice maker by lowering the wire signal arm.
Press and hold the Water Filter button on the
Ice & Water Dispenser control panel for three
seconds. When the display changes from Red to
Green, the status has been reset.
After replacing the water filter and in order for the ice
maker to work properly, it is necessary to clear air from
water filter tubing. Once ice maker begins making ice,
allow the bucket to fill completely, then discard the
first TWO FULL buckets of ice. It will take at least two
days to completely fill the bucket on regular ice making
mode or 11/2days on fast ice mode.