Frigidaire 242292000 Use & Care Manual page 10

You will be pulling approximately three feet of water
Installing Freezer Drawer
i With lower slides pulled out, hang drawer onto
slide brackets ensuring pins on each side are fully
inserted into slots on each side.
4 Unscrew the three lower hinge screws and hinge
if necessary,
To reinstall the right door, reverse the above steps,
Lower Hinge Removat
Fully Extenc
Drawer Slide
iili! iiI i
iii_ i
Cabinet
2 Reinstall four drawer screws (two per side), tighten
down, and close drawer (C).
Once both doors are in place, ensure they are aligned
with each other and level (Please see the "[nstallation"
section for more details), and replace the top hinge cover.
Be sure doors are set aside in a secure position where
they cannot fall and cause personal injury, or damage
to the doors or handles.
Removing Freezer Drawer
i Open freezer drawer.
2 Remove drawer screws on right and left sides (two
screws on each side).
l
Remove Hex
Head Drawer
Screw
Head Drawer
Screw
Remove Hex
Head Drawer
V
Remove Hex
3
4
5
Install ScrewS,
(2) Each Sid(_ \
z
z
Check gasket seal around top, bottom, and sides of
freezer drawer.
If gasket is not sealed, open drawer and slightly
loosen four drawer screws (two on each side) to
allow drawer to rotate.
Close drawer and recheck the seal on the gasket
(A). Open the drawer grabbing by the sides in the
center (B). Be careful not to rotate the drawer.
_geinst
Freezer
[}
Drawer is heavy. Use caution when lifting.
3 Lift drawer up and out to remove.
6 Tighten four drawer screws.
7 Recheck gasket sea[.
8 Install the toe grille by fitting into place.