Teach The Rf/Ir Conversion Codes For The Master Keys, Function Keys, And System Off Key - Niles Intellicontrol Tabletop Remote Manual

Learning IR touchscreens issue IR codes, therefore a Niles IR sensor must be connected
to the IntelliControl's "Home Theater IR" input.
Teach the RF/IR Conversion Codes for the Master Keys, Function Keys, and
System Off Key
Note: Every RF command sent by the IntelliControl identifies the last Master Key pressed
by the end user. For example; if the IntelliControl was busy executing the turn on
sequence for the DVD and the end user pressed the Master Key for the VCR, the Test
LED would light red to indicate that the system was busy.
Additionally, the command would be ignored by the system, but the remote's backlighting
would indicate that the system was playing the VCR, however the system is actually
playing the DVD. Any key press will correct the problem! The end user does not have to
press the VCR Master Key again.
Thus, the IntelliControl issues 331 different RF commands. You must teach the VCR's
"Play" key on your IR learning device the "Play" command which corresponds to the
Master Key page dedicated to the VCR in the IntelliControl system. Remember to do the
same with "Volume Up" and "Volume Down".
40