Table of Contents
Advertisement
TROUBLE-SHOOTING
Most treadmill problems can be solved by following the simple steps below. Rnd the symptom that
applies, end follow the steps listed. If further assistance
is needed, cail our toll-free HELPLINE at
1-800-736-'687g, _day
through Satut,day, 7 a.m. until 7 p.m. Central Time (excluding holidays).
PROBLEM:
THE POWER DOES NOTTURN
ON
SOLUTION:
a. Make sure that the power o_d is plugged into a surge suppressor, and that the surge suppressor
is plugged into a properly grounded outlet (see page 7). Use only a single-outlet surge suppressor
that is UL 1449 listed as a transient voltage surge suppresser ('I'VSS). The surge suppressor
must have a UL suppressed voltage rating of 400 volts or less and a minimum surge dissipation
of 450 joules. The surge suppressor must be electrk_lly rated for 120 volts AC and 15 amp6.
b, After the power cord has been plugged in, make sure that the key is fully inserted into the con-
sole. See step I on page 8.
c: Check the circuit breaker located on the treadmill
near the power cord. If the swttch protrudes as
=shown, the circuit breaker has tdpped. To reset the
cimuti breaker, wait for five rnlnutas and then press
the switch back in.
d. Check the on/off switch located on the treadmlll
near the power cord. The sw_ch must be In the on
position.
¢
Tdpped
Reset
d
Position
PROBLEM: THE POWER TURNS OFF DURING USE
SOLUTION:
a. Check the ctrcuit breaker located on the treadmill frame near the power cord (see 1. c. above). If
the cimuit breaker has tdpped, wait for f'Ne minutes and then press the switch back in.
b. Make sure that the power cord Is plugged in.
c. Remove the key from the console. Re|nsert the key fully into the console. See step I on page 8.
d. Make sure that the on/off switch Is In the on position.
e. If the treadmill still will not run, please call our toll-free HELPLINE.
PROBLEM: THE DISPLAYS OF THE CONSOLE DO NOT FUNCTION
PROPERLY
SOLUTION:
a. Unplug the power cord. Remove the s_ews from
the hood. Carefully remove the hood. Locate the Reed
Switch (21) and the Magnet (43) on the left side of the
Pulley (42). Turn the Pulley until the Magnet Is aligned
with the Reed Switch. Make sure that the gap be-
tween the Magnet and the Reed Switch is about
1/8". If necessary, loosen the Reed Switch Screw (76)
and move the Reed Switch slightly. Retighten the
Screw. Re-attach the hood, and run the treadmill for a
few minutes to check for a correct speed reading.
12
Hide quick links:
Advertisement
Table of Contents
