12.If the scanner is mounted 2 or more left of ship's bow, adjust the position of
S901 so it becomes "on" (contact between #1 and #2 on pcb MP-3795). To
access S901, open the bow side cover; S901 is above the drive gear.
RTB801
13.Confirm that all screws are tightened and all wiring is properly made. Coat
waterproofing gasket, bolts and tapping holes of scanner unit with silicone
grease. Check that the waterproofing gasket is seated as shown in Figure 2-5.
Close the scanner unit cover.
Coat gasket with silicone grease.
DO NOT use silicone sealant.
Figure 2-5 Correct seating of waterproofing gasket
1 2 3 4 5 6 7 8 9 10 11 12 13 14
15 16 17 18 19 20 21 22 23 24 25 26 27 28
Bow mark
Figure 2-4 Scanner unit, front view
2-3
S901
CORRECT
WRONG