Kenmore 790.7050 Series Use & Care Manual page 6

Important Safety Instructions
iMPORTANT iNSTRUCTiONS FOR CLEANING
YOUR RANGE
Before manually cleaning any part of the
range, be sure aii controls are turned OFF and the range is
COOL. The range may be hot and can cause burns.
* Clean the range regularly to keep all paris free of
grease thai could catch fire. Pay particular attention to
the area around each surface burner. Do not allow
grease to accumulate.
* Kitchen cleaners and aerosols m Always follow the
manufacturer's recommended directions for use. Be
aware that excess residue from cleaners and aerosols
may ignite causing damage and injury.
* Clean venillailng hoods frequently m Grease should not
be allowed to accumulate on the hood or filler. Follow
the manufacturer's instructions for cleaning hoods.
Conversion to L.P. Gas
J_ Personal injury or death from elecirlcal
shock may occur if the conversion to L.P. gas is not made
by a qualified installer or elecirlclan.
j!'_j[]_]_ Any additions, changes or conversions
required in order for this appliance to satisfactorily meet
the application needs must be made by a qualified
technician.
This appliance allows for conversion to Liquefied Petroleum
(L.P.) Gas.
If L.P. conversion is needed, contact your local L.P. Gas
provider for assistance. The L.P. conversion kit is provided
with this appliance and is located on the lower REAR (back
side) panel of the range. Before installing the kit be sure to
read the L.P. Installation Instructions and follow them
carefully when making the installation.
Grounding instructions
Avoid fire hazard or electrlcal shock. DO
NOT use an adapter plug, an extension cord, or remove
grounding prong from electrlcal power cord. Failure to
foffow this warning can cause serious injury, fire or death.
This appliance is equipped with a 3-prong grounding plug
for your protection against shock hazard and should be
plugged directly into a properly grounded receptacle. DO
NOT cut or remove the grounding prong from this plug.
For personal safety, the range must be properly grounded.
For maximum safety, the power cord must be plugged into
an electrical outlet that is correctly polarized and properly
grounded.
If a 2-prong wail receptacle is the only available outlet, it is
the personal responsibility of the consumer to have it
replaced with a properly grounded 3-prong wail receptacle
installed by a qualified electrician.
See the INSTALLATION INSTRUCTIONS packaged with this
range for complete installation and grounding instructions.
Power supply cord
with 3-prong
grounding plug.