Kenmore 790.7050 Series Use & Care Manual page 15

Care & Cleaning
Cleaning recommendation table
Surface type Recommendation
Control knobs
Painted body parts
Painted decorative frlm
Aluminum, plastic or vinyl trim
pieces
For general cleaning, use hot, soapy water and a cloth. For more difficult soils and
built-up grease, apply a liquid detergent directly onto the soil. Leave on soil for 30-
60 minutes. Rinse with a damp cloth and dry. Do not use abrasive cleaners on any of
these materials; they can scratch. To remove control knobs, turn to OFF position;
grasp firmly and pull straight off the shaft. To replace knobs after cleaning, line up
the flat sides of both knob and shaft; then push knob into place.
Control panel Before cleaning the control panel, turn all controls OFF, activate oven lockout (on
Control key pad membrane some models) and if needed remove any knobs from panel. Clean using hot, soapy
Decorative trlm (some models) water and a dishcloth. Be sure to squeeze excess water from dishcloth before wiping
control panel; especially when wiping around the controls area. Excess water in or
around the controls may cause damage to the appliance. When rinsing, use clean
water and a dishcloth and be sure to squeeze excess water from dishcloth before
wiping the control panel.
Oven interior & door liner Gentle stubbing with a soapy no-scratch cleaning pad will remove most spots. Rinse
with a 1:1 solution of clear water and ammonia. If necessary, cover difficult spots
Porcelain enamel broil pan and
with an ammonia-soaked paper towel for 30 to 40 minutes. Rinse with clean water
broil pan insert (some models)
and a damp cloth, and then scrub with a soap-filled no-scratch cleaning pad. Rinse
and wipe dry with a clean cloth. Do not allow food spills with high sugar or acid
content (mill<, tomatoes, sauerkraut, fruit juices or pie filling) to remain on the
surface; they may cause a dull spot even after cleaning.
The oven interior is porcelain coated and safe to clean with oven cleaners following
manufacturer's instructions. After cleaning, remove any oven cleaner or the porcelain
may become damaged during future heating. Do not spray oven cleaner on any
electrical controls or switches. Do not spray or allow oven cleaner to build up on
oven temperature sensing bulb. Do not spray cleaner on oven door trim, door gasket,
plastic drawer glides, handles or any exterior surfaces of the range. Clean any soils
from oven frame and door liner outside the oven door gasket. Clean with hot, soapy
water. Do not clean oven door gasket. Rinse using clean water and a cloth. For
additional cleaning information see General cleaning in the Care & Cleaning
section.
Oven racks Remove oven racks from oven cavity before cleaning. Clean by using a mild,
abrasive cleaner following manufacturer's instructions. Rinse with clean water, dry
and then replace in oven.
Oven door Use soap & water to thoroughly clean the top, sides and front of the oven door.
Rinse well. You may use a glass cleaner on the outside glass of the oven door. Do not
immerse the door in water. Do not spray or allow water or the glass cleaner to enter
the door vents. Do not use oven cleaners, cleaning powders or any harsh abrasive
cleaning materials on the outside of the oven door. Do not clean oven door gasket.
Stainless Steel (on some models) Only use cleaners and polishes that are specifically manufactured for cleaning
stainless steel. Always rub in direction of metal grain to avoid damaging. Do not use
cleaners wlfh high concentrations of chlorides or chlorine. Do not use harsh
scrubbing cleaners. Polish with a lint-free cloth. Always be sure to wipe excess
cleaner/polish off from the metal surface as
bluish
stains may occur during future
oven heating that cannot be removed. Clean heavier soils with hot, soapy water and
a dishcloth. Rinse and dry using clean water and a cloth.
Cookiop surface Do not use spray oven cleaners on the cooktop. See Cleaning the cooktop and burner
Surface burners grates instructions provided in the Care & Cleaning section.
Burner q rates
15