Table of Contents
Advertisement
Available languages
Available languages
4.
Complete
the Installation
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death,
fire, or electrical shock.
I.
Plug into a grounded
3 prong
outlet.
2.
Flush the water
system.
See "Prepare
the Water
System"
or
"Water
and Ice Dispensers."
NOTE:
Allow
24 hours to produce
the first
batch
of ice. Allow
72 hours to completely
fill
ice container.
te
W® e_"
Please
read
before
using the water
system.
Immediately
after
installation,
follow
the steps below
to make
sure that the water
system
is properly
cleaned.
I.
Open
the freezer
door
and turn off the ice maker.
The On/
Off
switch
can only be accessed
when the ice storage
bin
has been removed.
The switch
is located
on the freezer
door,
on the left side of the wall that surrounds
the ice storage
bin.
Move
the switch
to the OFF (right)
setting.
2.
Make
sure the water
filter
is properly
installed.
Do not use with water that is microbiologically
unsafe or
of unknown quality without adequate disinfection before
or after the system. Systems certified for cyst reduction
may be used on disinfected waters that may contain
filterable cysts.
3.
Flush
the water
system.
Use
a sturdy
container
to depress
and hold
the
water
dispenser
lever
for
5 seconds,
then
release
it for
5 seconds.
Repeat
until
water
begins
to flow.
Once
water
begins
to flow,
continue
depressing
and
releasing
the
dispenser
lever
(5 seconds
on,
5 seconds
off)
until
a total
of 3 gal.
(12
L) has
been
dispensed.
This
will
flush
air
from
the
filter
and
water
dispensing
system,
and
prepare
the
water
filter
for
use.
Additional
flushing
may
be
required
in some
households.
As air
is cleared
from
the
system,
water
may
spurt
out
of
the
dispenser.
Open the freezer door and turn on the ice maker. Move the
switch to the ON (left) position. Please refer to the "Ice
Maker and Storage Bin" section for further instructions on
the operation
of your ice maker.
•
Allow 24 hours to produce the first batch of ice.
•
Discard the first three batches of ice produced.
•
Depending on your model, you may want to select the
maximum ice feature to increase the production
of ice.
st
te}:s
(on so_>e mede s}
On some models,
your
refrigerator's
accessory
packet
includes
two air filters,
which
must be installed
prior to use. On some
models,
the air filters
are already
installed
at the factory.
The air filter
reduces
the buildup
of odors.
This helps to maintain
a cleaner
environment
inside
the refrigerator.
Installing
the Air
Filters (on some
models)
The filters should be installed in two separate locations.
Location 1:
Install one of the filters
behind
the vented
door, which
is located
(depending
on your
model)
along
either
the rear or left interior
wall
near the top of the refrigerator
compartment.
1.
Remove
the air filter
from
its packaging.
2.
Lift open
the vented
door.
3.
Snap
the filter
into place.
4.
Close the vented
door.
\
13
Advertisement
Table of Contents
