Table of Contents
Advertisement
Operating
Instructions
Vent
Latch
Getting Started
1.
Load dishwasher (See Preparing
and Loading Dishes).
,
Select desired OPTIONS (See
Option Selections). The indicator
light above the pad will glow
when selected.
2.
Add detergent (See Dishwasher
Dispenser & Detergents).
7.
Run hot water faucet nearest
dishwasher until water is hot.
Turn water off.
IIIIIIIIIIIIIIll
,
Add rinse aid, if needed (See
Rinse Aid).
,
To start, press START/CANCEL
pad. Or press START/CANCEL
l
pad to repeat the same cycle and
options as the previous cycle.
4.
Close door to latch.
5,
Select desired CYCLE (See Cycle
Chart). The indicator light above
the pad will glow when selected.
Wash Cycle Selections
Cycle times are approximate and will vary with options
selected.
• Hot water is necessary to activate dishwasher
detergent and melt fatty food soils.
• An automatic sensor will check the incoming water
temperature and, if it is not hot enough, the timer will
be delayed for automatic water heating in the main
wash.
- This happens even when HI-TEMP WASH option
has not been selected.
- When HI-TEMP WASH is selected, an even higher
temperature will be guaranteed to handle heavier
soil loads.
Advertisement
Table of Contents
