Table of Contents
Advertisement
4.
Using the hex bolts, flat washers and spring
washers removed at step 1, fasten the base
to the platform. The torque should be
between 19.6-24.5 N m.
Note: Longer hex bolts (M10X25) are
supplied with the installation materials. Use
them instead of the hex bolts removed
earlier if the mounting platform is very thick.
Transceiver
module
Flat
washer
Spring
washer
Figure 4 How to fasten the base to platform
5.
Unfasten the cable of the rotation detector
from the cable clamp.
Rotation detector
Figure 5 Antenna unit, inside view
Caution: Be careful not to pinch the
rotation detector cable when remounting
the shield plate.
Antenna base
assy.
5-10
mm
Platform
Hex bolt
(M10 x 25
or M10 x 20)
Cable clamp
Caution
6.
Unfasten 11 screws to dismount the shield
plate.
Shield Plate
Figure 6 Antenna unit, inside view
7.
Pass the antenna cable with connector
through the gasket and cable clamp, and
then tighten cable gland.
Be sure the shrink tubing on the antenna
cable is not covered by the gasket.
Figure 7 Antenna unit, inside view
8.
Referring to Figure 8, fasten the shield
cable to a screw (M4x 10) on the chassis to
ground the unit.
Connect 9 pin
connector
here (J801).
Figure 8 How to connect the antenna cable
to the antenna unit
2
Discard screw
marked with
Rubber
Gasket
Gasket
Cable Gland
Connect
shield here.
.
Hide quick links:
Advertisement
Table of Contents
