Ni-Mh Battery Pack - A&D FC-5000Si Instruction Manual

13-2. OP-02 Ni-MH Battery Pack
Using OP-02 Battery Pack
By using the OP-02 Ni-MH battery pack, the scale can be operated for around 10
hours, after a full charge and using no other options
1. After making sure that the battery switch on the battery pack is "OFF" position,
insert the battery pack firmly into the rear side of the scale.
Lock Screw
2. Tighten the lock screw on the battery pack.
3. When desired, turn the battery switch on to supply power to the scale. The display
will come on after its self-check.
4. Use the STANDBY/OPERATE key to
turn the display on or off. When the
scale is in standby mode,
a period appears in the
weight display
indicator.
When the count display shows "lo bat" for low
battery, the battery power is almost exhausted
and should be recharged.
Before getting to low battery, the display will
show "lo bat" on and off to indicate that the
battery power is coming close to low battery.
The STANDBY/OPERATE key only turns the display on or off (and
keeps the scale warmed up on standby). When the scale is not used
for a long periods, switch the battery switch to "OFF" position.
Recharging the Battery
1. Turn the battery switch off on the battery pack.
Battery Switch
STANDBY
as an
OPERAT
65
.
OP-02 Slot
TARE
STABL
ENTERED
8 88888 .
Standby Indicator
2 3 4 5 6 7 8 9 0 1 2 3 4 5 6 7 8 9 0 1 2 3 4 5 6 7
ACAI
123456789012345678901234567
SAMPLE
2 3 4 5 6 7 8 9 0 1 2 3 4 5 6 7 8 9 0 1 2 3 4 5 6 7
TOO LIGHT
123456789012345678901234567
. l o bat
C a l i b r a t i o n E n d
C a l i b r a t i o n w e i g h t ( k g )
123456789012345678901210 . 0 00
ZERO M+
TOTAL SCALE
881
.
pcs
881
pcs