Command Mode - A&D FC-5000Si Instruction Manual

12-5. Command Mode

In the command mode, the scale is controlled by commands that come from an
external device, computer etc.
Do not set f-06/07/08-01="1" (stream mode) to use with the command mode. if
you don't want to use command mode together with key mode or auto-print mode,
set f-06/07/08-01="4" (command mode only).
Use a D-sub 9 pin cable (straight type) to connect with a computer.
Option cable: AX-KO2466-200, D-sub 9 pin, 2m
Command List
Command
@ Start / stop continuous data transmission.
A Same as RESET key.
D Set a known tare weight.
Store the unit weight in use, other values and
E
specified item code to ID memory.
F Recall a unit weight from ID memory.
G Set a known unit weight.
I Same as the REMOTE SCALE key.
J Same as the TOTAL key.
K Same as the M+ key.
P Same as the STANDBY/OPERATE key.
Q Send data immediately.
S Send stable data after accepting command.
T Same as the TARE key.
X Request a list of the F-Function parameters.
Y Request a list of the ID memory contents.
Same as the ZERO key.
Z
ON Turn the display ON.
OFF Turn the display OFF.
?ID Send the ID number and item code in use.
?QT Send the pcs (count) data.
?WT Send the weight data.
?UW Send the unit weight in use.
Send the total (accumulated) M+ memory count
?AQ
d t
?AN Send the number of additions to M+ memory.
?TR Send the tare weight in use.
?MR Send the specified ID memory contents.
Definition
50
Notes
Key command
"D,1.23C L " sets the tare
R F
weight as "1.23kg".
Refer to the data format.
Refer f-01-05
"F123C L " recalls from
R F
ID000123.
"G,0.123C L " sets the unit
R F
weight as "0.123g" (or "0.123 lb").
Key command
Key command
Data depends on
f-06 07 08-02
/ /
Key command
The last data terminates with
<EOT> (04H)
Key command
Refer to the data format for the
reply.