Kenmore 795.6500 Series Use & Care Manual page 14

4. Removing and Attaching Freezer Handle
• Remove the cap (1) and the 2 caps (2) using a flat tip
screwdriver.
• Loosen the 2 screws (3), take off the handle (4), and
install it on the right.
• Attach the caps, (1) and (2) you removed earlier.
5. Installing Freezer Door
• Install the base grille (1).
• Install the door (3) onto the bottom hinge pin.
• Install the middle hinge (4) on the opposite side with
screws (5) and (9).
6. Installing Refrigerator Door
• Place the washer (6) on the middle hinge pin (7).
• Install the door (8) so that it fits onto the middle hinge
pin (7).
• Install the top hinge (10) with screws.
• Reinstall top hinge cover (11).
7. After Completing the Job
• Make sure that each at the four corners of the door
gasket is not folded over on itself. To ensure a good
seal, apply a small amount of silicon grease on the
gasket.
Corner
14