NEC Express 5800 Quick Start Manual page 19

2. In the console tree, click Computers.
3. Right-click the Web server that will run the management Website and click Properties.
4. On the Delegation tab, click Trust this computer for delegation to specified services only.
5. Click Use any authentication protocol.
6. Click Add, and then click Users and Computers.
7. Type the name of the computer running the Virtual Server service, and then click OK.
8. From the list of available services, hold down the CTRL key while clicking cifs and vssrvc, and then
click OK.
To install the Virtual Server Web application on a separate system that is running the management website:
1. On the computer on which you intend to install the Administration Website for Virtual Server, from
the Virtual Server 2005 CD-ROM start the Virtual Server Setup Wizard. If you start the Setup
Wizard manually, use Setup.exe.
2. Proceed through the wizard until you reach the Setup Type page.
3. On the Setup Type page, select Custom, and then click Next.
4. Click Virtual Server Service, select This feature will not be available, and then click Next.
5. On the Configure Components page, accept the default Website port value of 1024.
Figure 13 shows this interface.
6. Select Configure the Administration Website to always run as the Local System account, and
then click Next.
7. Click Install to begin the installation.
NEC Express5800 Fault Tolerant Virtual Server Quick Start Guide
Figure 13: Configure the Virtual Server Web Application port.
17