NEC Express5800/320Lb Windows Release Note page 11

8. Cautions regarding [Enable automatic module start.]
option in the ft server utility
The duplication of the PCI modules may not be performed properly if the
automatic startup is disabled by unchecking [General]-[System Settings]-[Enable
automatic module start.] option in the ft server utility. Especially when the
optional boards are installed.
Keep the automatic startup enabled.
Note:
If the PCI module maintenance is performed in the environment where this item is
unchecked, the PCI module may not be duplicated properly. In that case, please
follow the steps shown below.
1. Check [Enable automatic module start.] in the ft server utility and click
Apply].
2. When the HDD has been mirrored, open the ft server utility and stop the
PCI module of which status LED 2 is lit in green.
3. Remove the stopped PCI module once, and insert it back after waiting a
little.
4. After the HDD mirroring has been completed, the status LED2 on both
PCI modules will light in green, and the PCI module will be successfully
duplicated.
9. Cautions for removing the RDR setting of the HDD which
has been mirrored with RDR
When the RDR setting is removed from one of the HDD, which has been
mirrored with RDR, and the HDD does not have any partitions, the status LED2
of the PCI module which has the removed HDD may light in amber, and show
the non-duplicated status.
Do not uncheck this item.
Express5800/320Lb System Release Notes 9