Introduction; A Typical G-Pilot 3380 System Installation - Navman G-PILOT 3380 Installation Manual

1 Introduction

Using this manual
This manual describes how to install and set up
the G-PILOT 3380 system. Refer to the separate
G-PILOT 3380 Operation Manual for information
on how to operate the G-PILOT 3380 display unit.
To install a G-PILOT 3380 system, you must
perform installation, dockside setup and sea
trials (see sections 3, 4 and 5).
To fully set up a G-PILOT 3380 system after a part
has been changed or if a problem is suspected,
perform dockside setup and sea trials again
(see sections 4 and 5).

1-1 A typical G-PILOT 3380 system installation

Manual helm
Rudder
control
G-PILOT 3380 System Installation Manual
Display
unit
NavBus
Clutch drive
(optional)
Steering
drive
Rudder
To verify that the G-PILOT 3380 system is
operating correctly, perform sea trials (see
section 5).
Cleaning and maintenance
Clean the parts of the G-PILOT 3380 system
with a damp cloth or mild detergent. Avoid
abrasive cleaners, petrol or other solvents.
Do not paint any part of the G-PILOT 3380
system except for the cables.
More
display
units
0
MCU60
Power switch or
power protection
Key
Rudder
feedback
unit
NAVMAN
Optional instruments
WIND SPEED
Compass
switches and
Parts supplied with G-PILOT 3380 system
Other parts required
Optional parts
Note: Above shows typical installation
only. Please refer to the information
supplied with your drive for further
information.
GPS
NMEA
Gyro
Light duty
Heavy duty
12 V DC
Power supply
5