Menus; Setup > System - Navman G-PILOT 3380 Operation Manual

6 Menus

Many of the G-PILOT 3380 features and
functions are operated through menus.
• To scroll through menu items, scroll
through items in a list or change data
use the Control Dial. Clockwise scrolls
across/down or increments data.
• To select a menu item press
• To go back to the previous menu
press .
• To accept changes press
• To discard changes press
Note: Some menu items in the G-PILOT 3380
menus utilize checkboxes.
• If the box is 'checked' (contains a check
or tick), then that function is selected
(enabled) or ON.
6-1 Setup > System
Language
Select the language for
the display. The options
are: English, Italian, French,
German, Spanish, Dutch,
Swedish, Portuguese, Finnish
and Greek.
Tip: In case you can't read the current
language, the language setting is the first
item in the system menu.
Backlight
The backlight pop-up is displayed (see also
section 3-4).
The bar setting represents the current level of
backlighting.
Night Mode –Allows low contrast Night mode.
Auto – allows night mode to be selected in
backlight pop-up
On – night mode is active all the time
Off – night mode is not available
Key beep
Enables or disables an audible beep when a
key is pressed or Control Dial is rotated.
G-PILOT 3380 and Operation Manual
•
•
.
The main menu for configuring the G-PILOT
.
3380 is the Setup menu. Press
Setup menu is displayed (normally twice).
.
The Setup menu and options are summarized
in this chapter. The factory default settings are
shown where applicable. Each Setup menu
option is explained in the following sections.
Auto power off
About
Factory Reset Resets all settings to the factory
SmartCraft™ Select to enable SmartCraft
NAVMAN
If the box is 'un-checked' (does not
contain a check or tick), then that function
de-selected (disabled) or OFF.
To select or de-select a checkbox, highlight
the menu item using the Control Dial and
press . The change will happen
immediately.
Select to have the G-PILOT power off
automatically every time the boat's ignition
is switched off. This applies only if the
display unit is wired for Auto Power (see
installation manual).
Displays information about the unit.
default settings. A warning box asks: Are
you sure? Select Yes and press
confirm, or No or
Main control unit – Resets the MCU's
settings
Head unit – Resets just this head unit's
settings
Both – Resets the MCU's settings and this
unit's settings
functions. SmartCraft is only available with
certain Mercury engines, and requires a
SmartCraft Gateway. For more information
refer to the SmartCraft manual included
with the SmartCraft gateway.
until the
to
to cancel.
29