Meridian DSP5500 User Manual page 59

Controls
Test mode
Remote key Logo
CD 1L
Radio 1r
LP 2L
Tape 1 2r
Internally generated test signals
A number of internally generated test signals are available in Calibrate
mode. These include:
one sample width impulse with 2Hz repetition rate
four sample width impulse with 2Hz repetition rate
To switch from the input to the test signals:
1. Press the w or e menu key until you see a display like this:
OFF
indicating that signal generation is off.
2. Press the n or s menu key to move between a narrow impulse, a
wide impulse and pink noise, with these displays:
thin
FAt
To set the relative level of the tweeter:
1. Press the w or e menu key until you see a display like this:
t 0.0
indicating a relative tweeter setting of 0.0dB
2. Press the n or s menu key to move in 0.5dB steps over the range
±1.5dB
To set the relative level of the bass:
1. Press the w or e menu key until you see a display like this:
b 0.0
indicating a relative bass setting of 0.0dB
2. Press the n or s menu key to move in 0.5dB steps over the range
±1.5dB
Getting out of Calibrate
Once calibration is compete, switch the DSP5500 off and then on again
while pressing Clear.
This should bring you back into the normal playing state.
Input on Control?
DSP5500
D1 No
D1 No
D2 No
D2 No
Appendix 59
Channel
selected
Left
Right
Left
Right
DSP5500 User Guide