Download Print this page

Kenmore 110.2663 Series Quick Start Manual page 6

Advertisement

Available languages

Available languages

You should select the wash/rinse water temperature
based on the type of load you are washing. Always use
the warmest wash water safe for fabric and follow
garment label instructions.
Depending on location, water temperatures may vary by
season. The fill rate may also differ depending on the water
temperature selected.
J
8YSU'! SlIE!BIIIE©T@I
(WIMI£!I} 8 11TIIL
Heavy
Duty
Use this cycle for sturdy or heavily soiled loads. For the
maximum soil removal, you should set the Cycle Selector
(Timer) Control for the longest available time.
Normal
Select this cycle for cottons and linens used regularly. It
provides up to 10 minutes of wash time. The fast-speed
spin shortens drying time.
Permanent
Press
I
This cycle will give you up to 10 minutes of wash time
and provides a load-cooling spray rinse to reduce
wrinkling.
Delicate
This cycle combines slow-speed agitation and slow-speed spin
to gently remove soils and reduce wrinkles.
Spin Only
A drain and spin may help shorten drying times for some fabrics
by removing excess water. Set OPTIONS Control (if available)
to One Rinse. You should then set Cycle Selector (Timer)
Control to a Spin setting.
Rinse
& Spin
Select this option if you think an extra rinse is needed. Set
OPTIONS Control (if available) to One Rinse. You should then
set the Cycle Selector (Timer) Control knob to a Rinse setting.
J
TISIILE$1IITINI
= 881111 ant LEAR$
Before you call service...check
for the following.
Loud clicking and banging?
• The yellow shipping strap may still be in the rear of the
washer. Completely remove the yellow shipping strap.
• The washer should be level, and the feet should be firmly
on the floor.
Some sounds are normal but may be different from
those of your previous washer.
• The gears engaging after the drain and before the spin.
• The sound of air being pulled through the pump after most
of the water has drained.
Is the washer leaking?
• Fill hose connections are tight
• Gaskets in fill hose are tight and flat
• Drain hose clamp is securely attached
• Faucets drain/standpipe or laundry tub is not leaking
• The washer tub is centered and the load evenly balanced
at the start of each load
• The washer is level
• The front feet are installed and the nuts are tightened
to the cabinet
See the Use and Care Guide for complete details.
® Registered Trademark
/ TM Trademark / SM Service Mark of
Sears, Roebuck and Co., used under licensee by Sears Canada Inc.
8566911
3/05
© 2005 Sears, Roebuck and Co.
Printed in U.S.A

Advertisement

loading

This manual is also suitable for:

110.2664 series110.2665 series