American Audio VLP Series User Instructions page 6

Front Panel
VLP300
11. Channel 1 Gain Control - This rotary knob is used to control the
output signal of channel one. Turning the knob in a clockwise direction
will increase signal output.
12. Channel 1 Protect Indicator - The red Protect LED will begin to
glow when the channel goes into protect mode. When the channel goes
into protect mode all output for that channel will turn off. This is to pro-
tect any speakers connected to the channel.
13. Channel 1 Clip Indicator - This red LED will begin to flash when
channel one begins to overload (clip). At this point channel one will be-
gin to distort. Under heavy clipping activity lower the channel one gain
control to reduce the risk of damage to your speakers and amplifier. This
LED may glow when the unit has been turned off, this is normal.
14. Channel 1 Signal Indicators - These green and yellow LED's will
glow according to the average signal output.
15. Power Indicators - These LEDs function as a power indicator.
16. Power Switch - This switch is used to control the units main power.
17. Channel 2 Signal Indicators - These green and yellow LED's will
glow according to the average signal output.
18. Channel 2 Clip Indicator - This red LED will begin to flash when
channel one begins to overload (clip). At this point channel one will be-
gin to distort. Under heavy clipping activity lower the channel one gain
control to reduce the risk of damage to your speakers and amplifier. This
11 12 13
6
10
3
15 PRO
1
30
CH A
80 0 dB
©American Audio® - www.americanaudio.com - VLP Series™ Power Amplifier User Manual Page 6
14 15 16 15 17 18
PROFESSIONAL POWER AMPLIFIER
CLIP 10 15 POWER POWER 15 10 CLIP
VLP300
LED may glow when the unit has been turned off, this is normal.
19. Channel 2 Protect Indicator - The red Protect LED will begin to
glow when the channel goes into protect mode. When the channel goes
into protect mode all output for that channel will turn off. This is to pro-
tect any speakers connected to the channel.
20. Channel 2 Gain Control - This rotary knob is used to control the
output signal of channel two. Turning the knob in a clockwise direction
will increase signal output.
19 20
6
10
3
PRO 15
1
30
CH B
80 0 dB
Figure 2