American Audio VLP 2500 - REV 9-10 User Instructions

American Audio VLP 2500 - REV 9-10 User Instructions

Professional power amplifier

Advertisement

Quick Links

AmericAn Audio
®
6122 S. eastern Ave.
Los Angeles ca. 90040
rev. 9/10
VLP 2500

User Instructions

Professional Power Amplifier

Advertisement

Table of Contents
loading

Summary of Contents for American Audio VLP 2500 - REV 9-10

  • Page 1: User Instructions

    Professional Power Amplifier VLP 2500 AmericAn Audio ® User Instructions 6122 S. eastern Ave. Los Angeles ca. 90040 rev. 9/10...
  • Page 2 Fachpersonal durchführen lassen. aChtUng: um einen elektrischen Schlag oder Feuergefahr zu vermeiden, sollte diesen Gerät nicht dem regen oder Feuchtigkeit ausgesetz werden. vor inbetriebnahme unbedingt die Bedienungsanleitung lesen. ©American Audio® - www.americanaudio.us - vLP 2500 Power Amplifier user manual Page 2...
  • Page 3: Table Of Contents

    Front Panel........................................5 rear Panel........................................6 inputs...........................................7 outputs..........................................7 Speakon output connector Assembly...............................9 operating modes......................................10 Protection circuitry Limiter.........................................11 Short circuit Protection...................................11 Thermal Protection..................................12 Amplifier Features.......................................12 Speaker Setup......................................13 Warranty.........................................14 Specifications.......................................15 ©American Audio® - www.americanaudio.us - vLP 2500 Power Amplifier user manual Page 3...
  • Page 4: Safety Precautions

    The appliance has been exposed to rain or water. Fax: (323) 582-2941 d. The fixture does not appear to operate normally or exhibits a marked change in performance. ©American Audio® - www.americanaudio.us - vLP 2500 Power Amplifier user manual Page 4...
  • Page 5: Front Panel

    8. Channel 2 Clip Indicator - This red Led will begin to flash when channel one begins to overload (clip). At this point channel one will be- gin to distort. under heavy clipping activity lower the channel one gain ©American Audio® - www.americanaudio.us - vLP 2500 Power Amplifier user manual Page 5...
  • Page 6: Rear Panel

    Audio® service technician. 29. aC Cord - Plug this cable into a standard wall outlet. check that the voltage in your area matches the amplifiers required voltage. ©American Audio® - www.americanaudio.us - vLP 2500 Power Amplifier user manual Page 6...
  • Page 7: Inputs

    ©American Audio® - www.americanaudio.us - vLP 2500 Power Amplifier user manual Page 7...
  • Page 8 You can purchase the Speakon nL4Fc connectors from your local audio dealer. ® ©American Audio® - www.americanaudio.us - vLP 2500 Power Amplifier user manual Page 8...
  • Page 9: Speakon Output Connector Assembly

    CAUTION SPEAKON 1+ HOT 1 COLD MINIMUM LOAD IMPEDANCE 2 OHM PERCHANNEL 4 OHM BRIDGE - B I D E + UTPUTS 120 60 4800 A TTS ©American Audio® - www.americanaudio.us - vLP 2500 Power Amplifier user manual Page 9...
  • Page 10: Operating Modes

    To run in parallel mono mode connect your system as you would if you were going to run in stereo mode. Then flip the mode switch to “mono.” Be sure the amp is off or the power is disconnected before making any changes. ©American Audio® - www.americanaudio.us - vLP 2500 Power Amplifier user manual Page 10...
  • Page 11: Limiter

    "clip" Led and “Protect" Led will light simultaneously indicating amplifier fault. All channel output during the “Short circuit Protection" will be interrupted (i.e. no sound out ©American Audio® - www.americanaudio.us - vLP 2500 Power Amplifier user manual Page 11...
  • Page 12: Thermal Protection

    Led IndICators - each channel has five LedS. Two gree Leds indicate signal level activity. one yellow Led indicates signal clip- ping. one red Led indicates protection mode for shorts/ overload. one blue Led indicates power for each individual channel. ©American Audio® - www.americanaudio.us - vLP 2500 Power Amplifier user manual Page 12...
  • Page 13: Speaker Setup

    Mono brIDge set-Up use channel 1 inputs only (XLr or 1/4” Jacks) Figure 14 use the two positive binding post termainals (red) for speaker output. speaKers 8 oHm minimum ©American Audio® - www.americanaudio.us - vLP 2500 Power Amplifier user manual Page 13...
  • Page 14: Warranty

    This warranty is void if the serial number has been altered or removed; if the product is modified in any manner which American Audio® con- cludes, after inspection, affects the reliability of the product; if the product has been repaired or serviced by anyone other than the American Audio®...
  • Page 15: Specifications

    Factor @ + 450 8 ohm: impedance: 20K ohms Balanced 10K ohms unbalanced dimensions 17.8” x 19” x 3.5” (LxWxH): 453 x 482 x 88mm Weight: 49.8lbs/22.6Kgs American Audio® - www.americanaudio.us - vLP 2500 Power Amplifier user manual Page 15...
  • Page 16 ©American Audio® World Headquarters: 6122 S. eastern Ave. Los Angeles, cA 90040 uSA Tel: 323-582-3322 Fax: 323-725-6100 Web: www.AmericanAudio.us e-mail: info@americanaudio.us American dJ europe Junostraat 2 6468 eW Kerkrade netherlands service@americandj.eu / www.americandj.eu Tel: +31 45 546 85 00 / Fax: +31 45 546 85 99...

This manual is also suitable for:

Vlp 2500

Table of Contents