Kenmore 625.388270 Owner's Manual page 6

[i!i !! :i:_!! :i:_!! :i:_!! :i SECTION 1
WATER SOFTENER START UP
C. PROGRAM THE TIMER
salt level adjust UP button
signal light adjust
SELECT button
.... diii
f
t.EVEL LEVEL •
I /
P ss oR cu
TONIGHT 1-800-426-9345 [_
HOLD FOR www.KenmoreWatercom
IMMEDIATE
LOW
SALT
RECHARGE button DOWN button
When the transformer is plugged in, a model code,
and a test number (example: J]0) show in the face
plate display for 4 seconds. Then, J2:O0 AM and
PRESENT TIME begin to flash.
! I1-1
U fU
I I "-I,1--| I--I AMI
I I_-,LILI /
PRESENT TIME I
Notes:
If SR - - or .... shows in the display, press the
UP[] orDOWN[_ button until SR33 shows in the
display. Then, press the SELECT button to set, and
change to the flashing PRESENT TIME display.
To check the model code, unplug the transformer at
the wall outlet and plug in again, if other than this
code shows, see page 5-3 to reset.
SOUND "BEEPER": A "beeper" sounds while
pressing buttons for timer set-up. One beep signals
a change in the face plate display. Repeated beeps
mean the timer will not accept a change from the
button you have pressed, telling you to use another
button. For example, while setting the hardness
(step 2), the beeper sounds repeatedly when the dis-
play reaches 1 using the DOWN button, or the high-
est hardness setting using the UP button.
_SET PRESENT TIME OF DAY
If the words PRESENT TIME do not show in the dis-
play, press the SELECT button (FIG. 2) until they do,
or see the previous notes.
• Press the UP or DOWN buttons to set the present
time. Press UP to move the display ahead; press
DOWN to move the time backward.
If the present time is between
noon and midnight, be sure PM
shows.
If the present time is between
midnight and noon, be sure AM
shows.
I_I,I-"I"1PM
'DO I
PRESENT TIME
I h-II -AM
I I,_-I1_-I I
PRESENT TIME
Each press of the UP or DOWN buttons changes
the time by 1 minute. Holding the buttons in
changes the time 32 minutes each second.
1-3
Problems, Questions? Call 1- 800- 426- 9345 Kenmore Water Line