Honeywell ADEMCO LYNXR-I Security System User Manual page 37

Enter:
Your user code
Upon entering remote phone control mode the Lynx will announce "System, enter code".
Remote Phone Control Commands
To remotely disarm system:
To remotely arm in AWAY mode:
To remotely arm in STAY mode:
To remotely arm in AWAY or STAY mode with no delay:
To remotely activate X10 devices 1-6:
To remotely activate X10 devices 7 & 8:
To remotely deactivate X10 devices 1-6:
To remotely deactivate X10 devices 7 & 8:
To remotely Bypass zones:
To remotely activate Forced Bypass:
To remotely check system status: [
To end remote phone session:
NOTES: (1) Check with your installer to see if the Forced Bypass mode has been enabled.
(2) When bypassing zones, make sure a confirmation beep sounds for each zone that has been bypassed.
Remote Phone Control Feature
(within eight seconds)
Your user code
Your user code
Your user code
[#] + [4] + device no.
Your user code
[#] + [7] + device no.
Your user code
+ [6] + zone no.
Your user code
Your user code
✻
]
Hang Up or
Your user code
– 37 –
USER FUNCTIONS
+ [1]
+ [2]
+ [3]
Your user code
+ [#] + [4] + device no.
+ [#] + [7] + device no.
+ [6] + [#]
+ [9]
+ [2] or [3] + [0]