Honeywell T7350 Product Data page 35

Online Diagnostics
Connect to a thermostat and, using the "Monitor Data"
function, read diagnostic information including:
• Thermostat firmware version.
Configuration Option
Fan Operation
Extended Heat Fan
Extended Cool Fan
Control
HeatPump RevValve
Heat Output Stages
AuxStg
Heating Response
Heat Lockout
Heat Lockout Setpoint
Cool Output stages
Cooling Response
Cooling Lockout
Cool Lockout Setpoint
Cooling Valve
Heating Valve
Anticipator Authority
Application
Anticipator Authority
Cooling TR
Cooling IT
Cooling DT
Heating TR
Heating IT
Heating DT
Display Units
Clock Format
a
The Factory defaults listed here apply to all subbase models with the exceptions of the items listed in Table 21.
b
12:00 Noon is the default start point when time is unknown.
c
Only Available if user selected one or more of following: Dehumidification Reset, Dehumidification Minimum On, or Dehumidification Reheat.
d
Config ID cannot handle Standby setpoints. Keypad users cannot set Occupied setpoints that violate Not Occupied setpoint relationship. The T7350 algo-
rithm never allows the effective setpoint outside Not Occupied setpoints.
Table 20. Thermostat Setup Options Through PDA.
PDA
a
Factory Default Tool CnfgID
Conventional X X
Extend 90 sec X X
No Extended Op X X
Standard X X
ActvClg X X
X X
a
1 X X
6 cph X X
None X X
70° F X
a X X
3 cph X X
None X X
35° F X
Direct X X
Direct X X
Htg X X
4° F X X
X
a
a X
0 sec X
X
a
X
a
0 sec X
°F X X
AM/PM X X
T7350 COMMERCIAL PROGRAMMABLE THERMOSTAT
• Thermostat hardware version.
• Subbase hardware version.
• Run time error messages.
Conventional: Applications where equipment controls fan operation in heat mode.
Electric Heat: Applications where thermostat controls fan operation in heat mode.
The thermostat always controls the fan in cool mode.
No Extended Op: No extended fan operation after call for heat ends.
Extend 90 sec: Fan operation extended 90 seconds after call for heat ends.
No Extended Op: No extended fan operation after call for cool ends.
Extend 40 sec: Fan operation extended 40 seconds after call for cool ends.
Standard: Conventional equipment; Heat Pmp: Heat Pump.
ActvClg: Energize O/B on call for cool.
ActvHtg: Energize O/B on call for heat.
Stages of heat (conventional HVAC equipment). Set to zero for heat pump.
Three heat stages not available if configured for four stages of cooling.
Auxiliary Heat Stages (for heat pump applications): Number of stages (0,1, or 2).
3 cph: Standard response for heating system;
6 cph: Medium response for heating system; 9 cph: Fast response for heating system;
20 cph: Super fast response for heating systems.
None: No outdoor air temperature (OAT) lockout for heat.
Enable: Heat locked out when OAT is greater than Heat Lockout Setpoint.
Heat is locked out when OAT is greater than this setpoint.
Range: -40 to 120° F
Stages of cool (conventional), or number of compressor stages (heat pump).
3 cph: Standard response for cooling system.
4 cph: Fast response for cooling system.
Cooling response applies to compressors in heat pump applications.
None: No OAT lockout for cool.
Enable: Cool locked out when OAT is less than Cool Lockout Setpoint.
Cooling is locked out if the outdoor temperature is less than this setpoint.
Range: -40 to 120° F
Modulating Cooling Valve Action: Direct or Reverse. (T7350M only.)
Modulating Heating Valve Action: Direct or Reverse. (T7350M only.)
Htg: Authority applies to heating only.
Htg&Clg: Authority applies to both heating and cooling. (Found in Loop Tuning.)
Thermostat Anticipator Authority. Range: 2 to 15° F.
Cooling Throttling Range. Range: 1 to 30° F. (Found in Loop Tuning.)
Cooling Integral Time. Options: 0, 100 to 5000 sec. (0: disable.)
Cooling Derivative Time. Options: 0, 10 to 3000 sec. (0: disable.)
Heating Throttling Range. Range: 1 to 30° F. (Found in Loop Tuning.)
Heating Integral Time. Options: 0, 100 to 5000 sec. (0: disable.)
Heating Derivative Time. Options: 0, 10 to 3000 sec. (0: disable.)
Temperature Display: °F or °C.
AM/PM: 12-hour clock format. 24 hr: 24-hour clock format.
35
Description
63-2605—5