Inputs; Outputs; Limiter; Low-Cut Filter - American Audio V3000/V2000 User Instructions

INPUTS

Two input connector, XLR jack for balance and 6.3mm (1/4") TRS jack for unbalance.
•BALANCED
•SYMETRIQUE
•SYMMETRISCHE
•BALANCEADO

OUTPUTS

Strip back insulation 13-mm. Insert wire fully, tighten barrel.

LIMITER

The limiter has a fixed threshold and will prevent continuous clipping. Below clipping, and during
short clips on peaks, the limiter does not act on the audio signal. The limiter for either channel can
be disabled independently using the slide switch on the front panel.
LOW CUT FILTER
The low-cut filter removes ultra-low frequency information from the audio signal
that could damage or cause distortion in a loud speaker system. The dip switch
on the rear panel allows you to enable or disable the filter independently for
either Channel, as well as set it for either a 50Hz or 30 Hz cut-off. Always use
the 50 Hz filter setting if you are using the amplifier to drive a distributed line system (also known as
a constant-voltage line, 70 volt line, etc.)
Page 6 • American AUDIO V3000 / V2000 MK II Power Amplifier Instructions
INVERTING INPUT -
GROUND
NON-INVERTING INPUT +
(Banana Jack Connection)
13mm
1/2"
•UNBALANCED
•ASYMETRIQUE
•UNSYMMETRISCHE
•UNBALANCEADO
GROUND
NON-INVERTING INPUT +
OFF
ON
1 2 3 4
CH. 1
1 3
Low
Cut Filter
2 4
ON=30Hz
OFF=50Hz
CH.2
ON=30Hz
OFF=50Hz
Low Cut
Filter