Table 7: Factory Default Configuration Settings For Door 3 - Honeywell NetAXS-123 Installation Manual

Installing the NetAXS-123 Panels
Installation
Table 7
for the readers, inputs, and outputs when either a 1- or 2-door Add-On Board is attached to the
board-to-board connector on the controller board.

Table 7: Factory Default Configuration Settings for Door 3

Type
Input
Output
a
Readers A and B share the same connection.
Notes:
• Reader LEDs, while they are outputs, should never be used to control anything other than their
• Incorrect wiring of the reader to the panel can cause the panel to abnormally stop operating or
32 www.honeywell.com
lists the factory Add-On Board default settings for a door 3. These mappings should be used
Purpose Web
Default
Name
Egress/ Input 9:
Request to Door 2
Exit (REX) Egress
Door Status Input 10:
Door 2
Status
Reader Input 11:
Tamper Door
TMPR-A
Reader Input 12:
Tamper Door
TMPR-B
Lock Relay Output #11
Reader LED Output #12
AUX Relay Output #13
Reader Future
Buzzer Feature
associated reader LEDs.
to operate erratically.
Terminal Reader A
Block
Label
IO-TB2
a
Input 9
IN9 (REX)
IO-TB2
a
Input 10
IN10 (STS)
IO-TB3 Input 11
TMPR A
IO-TB4
TMPR B
IO-TB5 a
Output 11
LOCK
IO-TB7 a
Output 12
LED
IO-TB5
AUX
IO-TB7
a
Output 14
BZR
Reader B Other
a
Input 9
a
Input 10
Input 12
a
Output 11
a
Output 12
Output 13
a
Output 14