Replacing The System Board - Dell PowerEdge 2650 Service Manual

Replacing the System Board

CAUTION: Before you perform this procedure, read the safety instructions in your System Information document.
CAUTION: See "Protecting Against Electrostatic Discharge" in the safety instructions in your System Information document.
1. Replace the system board (see Figure 4-31):
a. Lower the front of the system board into the system board tray, under the tray levers.
b. Lower the system board onto its grounding tabs in the system board tray and slide the system board back until the board's plunger snaps into
place.
2. Replace the system board tray (see
3. Replace the system battery (see
4. Replace the microprocessors and VRMs (see
5. If necessary, replace the memory module, hardware key, and battery for the integrated RAID controller (see
Controller").
6. Install the memory modules (see
7. Replace the expansion-card cage (see
8. Replace the system fan bracket (see
9. Replace the cooling fans (see
10. Replace the power supplies (see
11. Replace the cover (see "Replacing the
12. Reconnect the system to its electrical outlet and turn the system on, including any attached peripherals.
Back to Contents Page
"Replacing the System Board
"Replacing the System Battery").
"Adding or Replacing a
"Installing Memory Modules").
"Replacing the Expansion-Card
"Replacing the System-Fan
"Replacing a Cooling Fan").
"Replacing a Power Supply").
Cover").
Tray").
Microprocessor").
Cage").
Bracket").
"Activating the Integrated RAID