GE SCB2000 Installation Instructions Manual page 2

Before you begin -- Read these instructions completely and carefully.
IMPORTANT - Save these instructions for local inspector's use.
IMPORTANT - OBSERVE ALL GOVERNING CODES AND ORDINANCES.
Note to Installer - Be sure to leave these instructions with the Consumer:
Note m Consumer - Keep these instructions with your Owners Manual for future reference.
WARNING: This appliance must be properly grounded. See "Electrical Requirements," page 5
If you have a question concerning the installa-
tion of this product, call the GE Answer
Center ® Consumer Information Service at
800.626.2000, 24 hours a day, 7 days a week.
If you received a damaged Oven, you should
immediately contact your dealer or builder:
Proper installation is the responsibility of the
installer. Product failure due to improper
installation is not covered under the GE
Appliance Warranty. See the Owners Manual
for warranty information.
For Monogram local service in your area,
1-800444d845.
For Monogram service in Canada, call
1-888-8804030.
For Monogram Parts and Accessories, call
1-8004126-2002.
• Use this appliance only for its intended
purpose.
CAUTION:
• This oven should be installed by a qualified
installer or service technician.
• Never use the oven for warming or heating a
room. Prolonged use of the oven without
adequate ventilation can be hazardous.
Check with local utilities for electrical codes
that apply in your area. Local codes vary.
Installation electrical connections and
grounding must comply with applicable codes.
In the absence of local codes, the oven should
be installed in accordance with National
Electrical Code ANSI/NFPA 70 or latest
edition.
Contents"
Design Information
Product Dimensions ......................................... 3
Advance Planning ............................................ 3
Tools and Materials Required ......................... 3
Cabinetry
Prepare the Opening ....................................... 4
Single Installation ........................................... 4
Installed Above a Single Oven ........................ 4
Installed Above a Warming Drawer ................ 4
Installation Preparation
Electrical Requirements ................................. 5
Install Junction Box ......................................... 5
Installation
Step h Remove Packaging and Parts .............. 6
Step 2: Route Conduit Through Cutout ........ 6
Step 3: Secure Oven to Cabinet ...................... 6
Step 4: Connect Electrical .............................. 7
2