GE Advantium PSB1200 Installation Instructions Manual page 11

Installation Preparation
PreparationWITH an AccessoryStorageDrawer
NOTE:MODELZSC1201CAN ONLYBEINSTALLED WITH AN ACCESSORY S TORAGE DRAWERIF INSTALLED ABOVE36-3/4".
MODELZSC1202CANNOTBE INSTALLED WITH AN ACCESSORY S TORAGE DRAWER. S EEINSTALLATION PREPARATION W ITHOUT
AN ACCESSORY S TORAGE DRAWER FORTHIS MODEL.
PREPARE THE OPENING {cont.)
Installation over another GE/Monogram
Under-the-Counter (UTC) oven:
30"-- I _,- 23-1/2"
-,4 ............................ _ ---- ---[-- ---
1"*
Construct Solid
Bottom Min.
3/8" Plywood
_Supported by
2x4or2x2
Runners all
Four Sides
:2" Min.
(3" Recommended)
*Profile modelsonly
• If Uou are mounting an Under-the-Counter
GE/Monogram oven over another, use the
dimensions shown. The middle rail separating
the two openings may need to be larger than
the 2" minimum shown.
PREPARE THE OPENING {cont.)
Installation under a GE/Monogram
Microwave Oven and over a Warming
Drawer:
.................... 23-1/2"
Per Oven
Re( uirement
1"*
Per Warming
Drawer Rec '
ConstructSolid
Bottom Min. 3/8"
_Plywood Supported
by2x4or2x2
Runnersall Four
Sides
3.5" Min.
(4.5"Recommended)
2" Min.
(3" Recommended)
×-Profile modelsonly
NOTE: Additional clearances between the cutouts
may be required. Check to be sure the oven
supports above the Warming Drawer location
do not obstruct the required interior depth
and height. See Warming Drawer installation
instructions for details.
-&CAUTION: For
p ersonal safety,
the
mounting surface must be capable of supporting
the cabinet load, in addition to the added weight
of this approximate 80-pound oven, plus
additional oven loads of up to 50 pounds
or a total weight of 1:30 pounds.
11