Error Displays - Clarion CX609E Owner's Manual

Problem
No sound heard
Sound is
interrupted or has
noise.
The device isn't
recognized.
Can't insert the
device.

8. ERROR DISPLAYS

If an error occurs, one of the following displays is displayed.
Take the measures described below to eliminate the problem.
Error Display
ERROR 2
ERROR 3
ERROR 6
ERROR 2
ERROR 3
(USB/MTP mode)
CUR ERR
HUB ERR
If an error display other than the ones described above appears, press the reset button. If the problem
persists, turn off the power and consult your store of purchase.
Cause
The device contains no MP3/
WMA/AAC files.
The files are not proper MP3/
WMA/AAC format.
Connectors are loose.
Some USB portable music
players may consume current
that exceeds the USB rating.
In this case, the unit's
overcurrent protection circuit
operates to stop the music
playback.
The MP3/WMA/AAC files are
improperly encoded.
The device is damaged.
Connectors are loose.
According to the state of
operation on the device, the
communication fault is
caused.
The device has been inserted
improperly.
The connector is broken.
Cause
A CD is caught inside the CD
deck and is not ejected.
A CD cannot be played due
to scratches, etc.
A CD is loaded upside-down
inside the CD deck and does
not play.
The files are not proper MP3/
WMA/AAC format.
The MP3/WMA/AAC files are
improperly encoded.
Overcurrent detection.
Do not support the HUB
devices.
Measure
Record MP3/WMA/AAC files properly to the device.
Use only properly encoded MP3/WMA/AAC files.
Disconnect the device and reconnect securely.
Check operation of portable music player.
Use only properly encoded MP3/WMA/AAC files.
Disconnect the device and reconnect. If the device is
still not recognized, try replacing with a different
device.
Disconnect the device and reconnect.
Try reversing the connection direction of the device
(usually the brand name surface should be facing
left).
Replace with a new device.
Measure
This is a failure of CD deck's mechanism and consult
your store of purchase.
Replace with a non-scratched, non-warped-disc.
Eject the disc then reload it properly.
Use only properly encoded MP3/WMA/AAC files.
Use only properly encoded MP3/WMA/AAC files.
Disconnect the devices and reconnect. If the devices
are still not recognized, try replacing with a different
devices.
Do not use the HUB devices.
31
CX609E