Ariens 916003 - AMP 24 Owner's Manual page 25

1
1. Swing Gate Spacer
2. Drive Plate
Figure 27
2
1. Swing Gate
2. Swing Gate Finger
3. Drive Plate
Figure 28
5. Pull idler away from traction drive belt
and remove belt from idler, drive pulley
and driven pulley.
6. Replace traction drive belt.
7. Swing drive plate toward friction disc to
slide finger into stop hole in frame.
Reinstall swing gate spacer.
NOTE: Make sure drive plate spring remains
connected to the frame and drive plate.
8. Replace attachment drive belt (See
Replace Attachment Drive Belt on
page 24).
2
OS2630
3
1
OS8068
ATTACHMENT CLUTCH/BRAKE
ADJUSTMENT
WARNING: IMPROPER
ADJUSTMENT could result in
unexpected movement of auger and
impeller causing death or serious
injury. AUGER / IMPELLER MUST
STOP within 5 seconds when
Attachment Clutch/Impeller Brake
Lever is released.
Remove Attachment Cable Slack
1. Loosen the hardware securing belt
cover to unit.
NOTE: DO NOT completely remove the
hardware from unit.
1. Remove the belt cover.
2. Loosen jam nut (3) on cable adjustment
barrel (2), and then turn the adjustment
barrel down to shorten cable and
remove all cable slack. See Figure 29.
1. Attachment Clutch Cable
2. Cable Adjustment Barrel
3. Jam Nut
3. With the attachment clutch disengaged,
check that the attachment idler arm
lightly touches the frame. See Figure 30.
4. Tighten jam nut on cable adjustment
barrel.
GB - 25
Figure 29
OS2645
1
2
3