V2000Plus - American Audio Professional Power Amplifier User Instructions

V2000plus

V2000 V2000plus REAR PANEL
1
1. Cooling Fan -
Dual speed cooling fans. These fans are used to cool the internal parts
of the amplifier. Never block the fan grills in any way or mount in an en-
close rack, doing so may cause the amplifier to overheat and fail.
2. Channel 2 Input -
Connect the input source for channel two to either the balance XLR or the
balanced/unbalanced 1/4" input jacks. The 1/4" TRS plug is configured
as follows; Tip is positive, Ring is negative and Sleeve is ground. The
XLR jack is configured as follows; Pin three positive, pin two negative,
pin one ground. See page 9 for more details on input configuration.
3. Low Cut Filter Mode Switches -
These dip switches are used to active and adjust the built-in Low Cut
Filter, see "Low Cut Filter" on page 14.
4. Channel 1 Input -
Connect the input source for channel one to either the balance XLR or the
balanced/unbalanced 1/4" input jacks. The 1/4" TRS plug is configured
as follows; Tip is positive, Ring is negative and Sleeve is ground. The
XLR jack is configured as follows; Pin three positive, pin two negative,
pin one ground. See page 9 for more details on input configuration.
5. Mono-Bridge/Stereo Selectable Switch -
This switch changes the amplifier operating mode from either stereo or
mono bridge. Amplifiers are shipped in stereo mode.
6. Fuse Holder -
2
1
2
7 8 9
American Audio - www.americandj.com - V - www.americandj.com - Vplus - www.americandj.com - Vplus
®
3 4 5
3
4
10 11
This holder houses the external fuse. Always replace with the exact
same type fuse unless otherwise instructed by an authorized American
Audio technician.
®
7. Channel 2 XLR THRU Jack -
This jack is used to send a parallel signal from the channel two input
jacks to another device or amplifier.
8. Channel 1 XLR THRU Jack -
This jack is used to send a parallel signal from the channel one input
jacks to another device or amplifier.
9. Channel 2 Output Jack/5 way Binding Post -
Connect to your speaker's input jack. Red is positive signal and Black is
negative signal.
10. Channel 1 Output Jack/5 way Binding Post -
Connect to your speaker's input jack. Red is positive signal and Black is
negative signal.
11. Ground Lift Switch -
This switch is used to disconnect the internal ground signal from the
amplifier chassis ground. This may reduce the buzz that is caused from
an electrical 60Hz cycle.
12. A/C Power Input -
Plug this cable in to a standard 110~120v wall outlet. Never plug your
amplifier in to a wall outlet that does not match the required voltage of
your amplifier, serious damage may occur to your unit. your amplifier, serious damage may occur to your unit.
Series Amplifiers Power Amplifier User Manual Page 7
6 1
12
Diagram 3