And Density - Sears Kenmore 385.19030 Owner's Manual

Sensor Buttonhole, cont_d
Remove the fabric and place a pin just before the
barrack at each end to prevent cutting bartackso
Cut the opening with the buttonhole opener.
When finished, push the buttonhole lever up as far
as it will go_
If the button is extremely thick, make a test buttonhole.
If it is difficult to fit the button through the test
buttonhole, lengthen by pulling the button holder on
the foot back to increase length.
(_) Gap
• To Alter Buttonhole Stitch Width and Density
The pre-programmed stitch setting are shown on
the screen.
Each time "-" or" + "is pressed, the width and length
wilt be changed°
'_ Adjust the stitch density as appropriate for the
material and thread.
- Denser stitch for thin material
- Coarser stitch for thick material
(_) Narrow
(_) Wide
(_ Dense
(_ Coarse
@
W5.0 L--0A.4
t
WIDTH
@
LENG_
@ @
56